2017 Renegade

Hello. When I'm programming the Evo-All on a 2017 Jeep Renegade, the blue LED starts blinking after 5 seconds (after pressing the button), and after turning off the ignition, the red LED stays on continuously. I've already tried it on two modules.

asked Jun 12 in Jeep by G M (20,120 points)

1 Answer

Red ON solid while blue flashes is typically pointing to CAN2 not read properly.

answered Jun 12 by Robert T (310,630 points)

No. I mean, after the blue light starts flashing and I turn off the ignition, the blue light goes out and the red light turns and stays on.

commented Jun 12 by G M (20,120 points)

Continue cycling ignition On then Off slowly. Can take up to 10x.

LED should go yellow with ignition on, then red with ignition off. At some point it will start alternating red/yellow

commented Jun 12 by Robert T (310,630 points)

Like this

https://fortin.ca/download/103241/EVO-ALL_IG_RTS_BI_CHR6-7-COMPASS_2021_PTS_A_103241.pdf

commented Jun 12 by Robert T (310,630 points)

Yes, turning the ignition ON 10 times, helped. Thank you very much...

commented Jun 13 by G M (20,120 points)

Questions & Answers

2017 Renegade

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Questions & Answers

2017 Renegade

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions