Questions & Answers - Recent activity in Pontiac

Answered: Does your can bus interface work with a 2005 Pontiac gto

Thu, 07 May 2026 12:06:42 +0000

Hello,

At this time Fortin does not offer any bypass solutions for the 2005 pontiac GTO.

Best regards

Answered: Reset 2 units

Fri, 27 Jun 2025 12:07:09 +0000

Hello,

Modules with a manufacture date of 2017 and older cannot be configured using the flash link or reset. Please use a unit with a manufcature date of 2018+.

These units can still be used as is as long as the vehicle it is being installed into requires no computer configuration of the evo.

002B02183915 = fw 75.38

002B02172354 = fw 71.44

Thank you.

Answered: 2004 pontiac grand prix gt1

Thu, 16 Jan 2025 14:42:01 +0000

Hello,

Fortin does not offer an all in 1 solution for this vehicle, Fortin does offer immobilizer bypass (pats-gm), however it has not been made in some years now so you would need to find NOS online if possible.

You would still need to purchase and wire in a remote starter module aslong with the pats gm.

https://fortin.ca/en/vehicles/pontiac/grand-prix/2004-standard-key/compatibility/

Best regards.

Commented: 2004 Pontiac Vibe Install

Wed, 12 Jan 2022 19:29:11 +0000

Thank you again for the help. Definitely came in handy in finding what the problem was.

Answered: is there a t harness for an 2007 pontiac g5

Sun, 27 Dec 2020 15:06:18 +0000

there is no tharness available i just installed one last week make sure to use the software that the guide reccomends

Commented: 2016 Jeep Wrangler Viper 4606v evo all

Mon, 14 Sep 2020 11:47:31 +0000

I solved the problem was the tach I changed for voltage when I program tach won't start it working only on voltage mode for any reason

Answered: Remote start help

Wed, 01 Apr 2020 08:31:55 +0000

Is the vehicle equipped with an immobilizer?

If yes, what bypass module have you used?

Does the car remote start if you put the key in the barrell?

Commented: cruise control is not working after install the Evo One on Pontiac pursuit

Wed, 05 Jun 2019 21:45:11 +0000

2007 , i sold the car any way and still no idea what wrong was. thank you

Commented: installing cs800s w fortin int-sl+ every thing works fine while key is in switch what am i not getting hooked up

Mon, 18 Mar 2019 14:00:31 +0000

Hey Mike I hate to hijack this thread, but I was hoping you could help me. I am trying to install the same setup in my Buick Rendezvous which is pretty similar to the aztek. Could you tell me which wire you connected the Green igniton wire from the compustar to on the car? And the blue ignition wire? And what about the pink ignition wire on the Fortin unit? Thanks.

Commented: Anyone successfully done a 2007 Grand Prix with an Evo one?

Mon, 17 Dec 2018 17:14:34 +0000

Yes I am aware that they don't boast a solution for that vehicle for an evo one. However, they don't support other vehicles that I have posed questions for and have gotten firmware solutions for those vehicles. The 99-05 Grand am sports the same immobilizer along with many other GM vehicles. Just trying to see if anyone has tried to do it with those firmware verisons.70.18- 70.21 is the firmware I am checking for.

Answered: Bypass solution for 2005 Pontiac vibe

Tue, 06 Nov 2018 12:06:02 +0000

Pretty sure Vibe did not have transponder in 2005.

Commented: Missing Data wire

Tue, 30 May 2017 13:43:23 +0000

Charlie, glad you got it going! Not sure why datalink was griefing your previous setup.
If you ever come across something like this again, I would highly suggest NOT letting the remote start do it's autolearn datalink protocol selection. Force into whichever protocol by manually programming it.

2007 Pontiac G5, Manual Transmission, Evo-One, how to wire clutch bypass

Sun, 08 Jan 2017 14:01:47 +0000

Just wondering how to wire in the clutch bypass.

Answered: LED does not flash during programing. 2005 Pontiac G6

Mon, 19 Dec 2016 14:46:36 +0000

Try not to press lock on the cs800 before turning ignition.

Also the led can take a good time before starting to flash, leave the key on for a good minute.

Commented: FX64-2W WITH EVO ONE pontiac pursuit

Sun, 04 Dec 2016 16:26:48 +0000

the remote starter not working , all wires as manual and tested for polarity , the yellow loop i even cut for automatic but in this manual did not say about that ,any help

Commented: INTSL+ 2003 Pontiac Montana security light takeover

Tue, 08 Nov 2016 09:47:47 +0000

That would be my next suggestion. Make the car shut down on door open so the client does not have to see the light.

Commented: Pre loaded EVO-FORD , EVO MAZDA that is flashed to Pontiac would it work?

Thu, 17 Mar 2016 15:17:17 +0000

A combo package such as the EVO-FORT1 comes with an EVO-ALL that is preflashed for Ford/Mazda vehicles. You can still use the unit on any vehicle that is compatible with an EVO-ALL, but unless it's a Ford/Mazda, you will need to flash the evo-all for the appropriate vehicle make!

GM 70.XX
Ford/Mazda - 71.XX
Nissan/Infiniti - 72.XX
Honda/Acura - 73.XX
Chrysler/Dodge/Jeep - 74.XX
Volks./Audi - 75.XX
Hyundai/Kia - 76.XX
Volvo - 77.XX
BMW - 78.XX
Toyota/Lexus/Subaru - 79.XX

You dont need to memorize that list becuase when you plug an evo-all in the flash-link and select the vehicle you are working on, it will already list you the recommended firmware for that vehicle.

I'd like to add that, if this ProStart starter is an Autostart brand and not a Crimestopper brand, and if you are using datalink, you would have to actually select EXpressKit in the remote starter options and also enable option F3-D2D in the EVO-ALL. These Prostart remote starters do not offer 2-way Datalink in Fortin or ADS protocols; it's only offered for their native D2D protocol.

Comment edited: Is there a way to bypass 1998 Grand-Am with a single wire to Car Data Connector pin # 2 or Pin #9

Thu, 26 Mar 2015 14:04:08 +0000

The passlock sl2 should do the job if your can program it before taking everything out of the vehicle. All you would need to do is activate the passlock sl2-v2 via the ground-when-running input whenever you would want to start your Snow Plane. Worth a try if you have one in stock, your call on that.

I have never seen snow planes until today. I'm happy now, my day feels complete..

Answered: so i conect a 180 ohms resistor between the clutch switch and ecm?

Thu, 26 Feb 2015 08:51:05 +0000

You need to connect the 180 ohm resistor in series (in line) with the Ground out when running wire(from the remote starter) and the clutch switch wire (of the vehicle)

Comment edited: 2010 pontiac g5 clutch bypass

Tue, 24 Feb 2015 22:02:12 +0000

so i conect a 180 ohms resistor between the clutch switch and ecm? or the remote start and green wire?

Commented: 2004 montana doesn't start

Wed, 21 Jan 2015 22:02:45 +0000

I did put it to acc and all is working good. My stupid mistake.

Thanks for great help !!

Marc.

Answered: Would a 2007 Pontiac Vibe be the same as a 2007 Toyota Matrix?

Tue, 13 Jan 2015 13:03:05 +0000

the 2007 may actually not have a transponder to bypass.

Answered: Evo all rap shutdown bonneville

Tue, 06 Jan 2015 11:43:59 +0000

If you press lock after the shut down and it turns off the lights, just have the remote starter relock after start. If that does not work, you can always just wire the door trigger to the remote starter after shutdown output.

Commented: EVO-ALL not shutting down RAP 2002 Bonneville

Mon, 05 Jan 2015 10:08:18 +0000

It's not the actual security light. It's a service theft system message in the information center (LCD screen on the dash). The security light turns on and then goes out after remote start. I think the message continues even after the key is inserted but I'm not 100% sure on that. It doesn't come on when the key is used to start the vehicle.

My primary issue is with the RAP, the radio continues to play after remote start abort.

Commented: 08 Pontiac Torrent Won't program

Mon, 29 Dec 2014 11:46:17 +0000

I ended up using an idata module. Thanks though!

Answered: How do I contact a REAL person?

Mon, 24 Nov 2014 10:15:38 +0000

In the case that you're not in Montreal... 1-877-336-7797

Answered: Will this work with a 2011 G5?

Fri, 21 Nov 2014 13:50:16 +0000

probably like a 2010

Answered: DOES INT-SL-PL WORK WITH 2001 PONT GR PRIX IT'S NOT LISTED

Mon, 22 Sep 2014 13:15:16 +0000

Int-sl-pl is not listed for your vehicle, and also does not really exists anymore.

Compatible products for your vehicle can be found here : https://fortin.ca/en/vehicles/pontiac/grand_prix/2001/

Keep in mind that all these systems are meant to work with remote starters and only offer transponder bypass during remote start.

Answered: I am getting nothing.

Tue, 04 Feb 2014 10:03:31 +0000

Hi Scott,

What is the 12 digit service number written on the back of the EVO?

If you want to anything by email, send it to support@ifar.ca , comments/answers will be posted here after.

If you're only having problems with lock and unlock not working, this is most of the time related to the "Data Key Less" connection between the EVO and the BCM in your center console.

When the EVO receives a negative lock or unlock signal, you should be seeing a Blue light flicker on the unit. A quick and easy test, would be to ground yourself the purple or purple/white of the EVO to see if it makes a difference with your door locks.

with out the special key present I can still start the car.

You will need to contact the advanced keys tech support for this.

Commented: how do i know if my evoall has the correct firmware my 2004 montana requires 4.06

Tue, 14 Jan 2014 20:57:19 +0000

so i bought the flashlink and was able to download 4.06 and programmed my evo-all. connected all 3 wires and connected it to the van and prostart module. now all the lights flash but the van does not crank or start. where is the problem?

Answered: Will my key override all work on a vehicle not listed? 2000 pontiac bonneville

Mon, 06 Jan 2014 10:05:53 +0000

Hi Justin,

Unfortunatly, the only working bypass module for that specific vehicle are Evo-All, INT-SL+ or PATS-GM.

Have a nice day

Answer selected: Just wanted to confirm the evo-all will work on the passlock or passkey of a 2005 pontiac pursuit.

Tue, 10 Dec 2013 11:43:38 +0000

Hi,

The Passlock-SL2 will always work for the bypass.

The EVO-ALL will work ior the bypass, but only if the vehicle is equipped with a PK3+ system(There would be a "+" engraved into the shaft of the key if this is the case.

Commented: 2007 Pontiac G6 EVO-ALL

Thu, 05 Dec 2013 13:44:23 +0000

The accessory is coming on at the same time as the ignition. Am I better off to bypass the passlock with resistors?

To my knowledge, the problem would still be there afterwards since your accessory comes on with ignition.

I've seen people power accessory with the (+) parking light output instead. The only downside of this, is that when you do lock or unlock the accessory turns on, BUT if you are comfortable with relays, their may be a trick to power accessory using the parking light output ONLY when the remote starter wants to start the car.

Before doing anything else though, you may want to try this very simple test.

remove the accessory connection of the remote starter to the car.
remove the EVO yellow wire connection
connect yellow wire of EVO to remote starter accesory wire.

Next, I'd recommend contacting the manufacturer of the remote starter to see if they have any fixes for their problem.

Recategorized: 2008 Pontiac G5 evo all security light stay on after remote start.

Thu, 21 Nov 2013 09:41:16 +0000

Do I need a soecific update on evo all ?

Answer selected: installed all wires but the blue one

Mon, 18 Nov 2013 10:15:51 +0000

The red light will only turn on when the unit is active. It will activate when a ground is present on the blue wire. So basically, what you are describing, means everything is working as is :)