/en/qa/tag/2016-ford-explorer Powered by Question2Answer /en/qa/94380/evo-fort3-standalone-1-key-with-rfkit-fortin-642-not-remote-starting-explorer-piu Hello,<br /> <br /> installed EvoFort3 standalone RS with 1 key to 2016 Ford Explorer PIU that is prewired with hood pin switch with no actual hood switched. I jumped the wires at the connector. Installed the harness per the guide with all options on with the Fortin f642 2way kit. Car will lock unlock etc but with the remote start, it does not crank. After the 2 attempts the Red LED flashes 3 times. With the wires jumped it does not show that the hood is open. Do i need to get that changed at the dealer? Assistance greatly appreciated.<br /> <br /> walter Ford /en/qa/94380/evo-fort3-standalone-1-key-with-rfkit-fortin-642-not-remote-starting-explorer-piu Wed, 01 Jan 2020 14:57:17 +0000 /en/qa/94319/pin-14-in-20-pin-connector-empty-slot-to-ground-there-is-a-pin-in-that-slot-currently I was going to install the Evo all fort 3 standalone 1 key to a 2016 ford explorer with fortin remotes for unlock and lock. on the instructions it says to ground empty pin 14 slot of 20 pin connector. i checked this slot and it currently has a wire in it. the explorer does not have an OEM hood pin. please help. should i tap into the wire and ground or cut and ground the wire connected in pin 14? or do i even need this step? thank you for your help. Ford /en/qa/94319/pin-14-in-20-pin-connector-empty-slot-to-ground-there-is-a-pin-in-that-slot-currently Tue, 31 Dec 2019 00:52:28 +0000