/en/qa/tag/2020-subaru-forester Powered by Question2Answer /en/qa/132391/2020-forester I installed Evo-One on 2019 (2020 model) Subaru Forester (PTS). The rear edge of the fuse box was not as shown in the diagram... And I did not find any CAN wires there. Then I connected the CAN wires to the red and blue wires in the connector, next to the IMMO DATA wires. I programmed it successfully, but when trying to start the remotely, only the ignition opened... The starter did not turn (the starter wire is not indicated in the diagrams). Then, I connected the starter wire to the gray-red wire next to the IMMO-DATA wires. The engine started, but the doors did not open from the standard remote control. After that, I connected the CAN wires to the white and black wires in the connector on the back of the dashboard. And already opened the doors... Subaru /en/qa/132391/2020-forester Mon, 13 Jan 2025 09:00:46 +0000 /en/qa/127533/2020-subaru-forester-install-questions 1. In this thread from a while ago, it was said that enabling 3x lock is not recommended for a 2019. &nbsp;Does this still apply?<br /> <a href="https://fortin.ca/en/qa/90775/LockLockLock-Forester-Sport-2019/" rel="nofollow">https://fortin.ca/en/qa/90775/LockLockLock-Forester-Sport-2019/</a><br /> EDIT: May have been fixed in firmware 1.24 AKA 0.60?<br /> <br /> 2. Guide 98941, page 7. &nbsp;I&#039;m probably over analyzing this, but I assume for the Yellow/Red and Yellow/Green wires, the illustration is saying to connect the respective wires together. &nbsp;Is that correct? &nbsp;I figured there would be a black circle on it if that was a case. &nbsp;I initially thought this was a spliced wire from the factory.<br /> <br /> 3. Will there be issues if I use an Omega RF kit and have to use firmware 0.44?<br /> <br /> Thanks all! Subaru /en/qa/127533/2020-subaru-forester-install-questions Mon, 26 Feb 2024 21:34:52 +0000