EVO ONE wont start

Fri, 01 Mar 2019 07:17:52 +0000

I have a 2017 Santa Fe Sport 2.4 keystart and installed an EVO ONE with 3 lock start. First, the wire it says to cut in step 60, plug high behind fuse box is not grey/orange, it is white. The plug is not actually plugged into anything, just capped off. I flashed the unit with latest software. Everything is wired exactly as it says, except for ems com, since there is no wire. I programmed it as the instructions say, and it flashes blue. When I go to start the car, the blue light blinks with each push, but nothing. All connections seem fine, but still nothing. No horn, no flashing.

2011 chevy cruze step 5 will not change from yellow to red just stays yellow

Wed, 17 Jan 2018 21:44:47 +0000

2011 Chevrolet Cruze, standard switchblade key with ignition cylinder on column (not push to start). Using EVO-GMT1, with the t-harness. Only wire I have wired to the vehicle for now is the brown wire on the 5 pin connector, and that is spliced into the number 1 pin at the dlc for can bus. I can get programming to step 5. I have hit the program button 5 times, and it will flash 5 times in 4 sequences, and then stay on yellow when its done. When i turn the key it stays yellow and nothing happens. I do not want any other feature this offers, except 3 lock remote start. I have verified switching 0-3v at the brown terminal with key on, and have wired it multiple ways to verify it's not something I did.

I was able to get it to turn red once, turned the key off, removed the key, waited 5 seconds, and turned the key back on and it stayed red.

I am a gm technician and very familiar with these vehicles but I can not get this thing to program.

Questions & Answers - Recent questions tagged 3x-remote

EVO ONE wont start

2011 chevy cruze step 5 will not change from yellow to red just stays yellow