Questions & Answers - Recent questions tagged auto-lights

Autolights, foglights and high beams stopped working after installing EVO-RS TOY6 on 2017 Lexus NX200t

Sun, 20 Feb 2022 20:32:47 +0000

Just installed EVO-RS TOYT6 (EVO-ALL + TOY6) on 2017 Lexus NX200t for OEM remote start (3xLock) and works fine. The only issue is that autolights do not work (lights do not turn on even if it's dark outside) and foglights do not work, either.

EDIT: Also noticed high beams won't turn on, either. The "symbol" indicator shows up on the dash but the physical beam lights do not turn on.

Anybody has a fix for this?

Automatic lights do not work after install on 2018 RAV4

Sat, 23 Nov 2019 18:55:20 +0000

I've just finished installing the wiring on my 2018 RAV4 XLE Hybrid and now the automatic lights do not work.

NOTE: I've only connected the wires and the EVO-ONE is not connected yet.

I'm using the Fortin THAR-TOY6 harness and I've connected everything exactly as described in the manual:

1) Purple wire to (+) STARTER. (soldered connection)
2) White/Black wire to (-) START/STOP. (soldered connection)
3) +12V and GND wired to OBD2 per manual. (used Posi-Tap connectors; there is absolutely no way to pull OBD2 connector far enough out to solder wires behind connector)
4) "A" harness/passthrough connected to Main Body ECU.

I do not have an EVO-ONE yet but I wanted to finish the wiring. All car functions still work properly except the automatic lights.

What can I check to see why they are not working? I was extremely careful during installation and can't imagine why it's not working except that I don't have the EVO-ONE installed yet.

Disarm Pulse.

Tue, 15 Aug 2017 09:13:59 +0000

Hello

I have an Evo One setup up with a 2017 Chevy Cruze. Does the Disarm output A6 Orange on the Evo One give a negative pulse outpiut on remote start. I need a neg pulse to disarm the auto lights and as the GWR wire will be used for starter kill, this seems to be the best option.

Regards

Pat Lynch

driver door will not lock after remote start

Tue, 21 Oct 2014 13:33:15 +0000

2013 Kia Sorento LX pushbutton start, evo all hardware 6, firmware 4.18, remote starter brain compustar cm800. Reference used for installation ... evo-all_kia_sorento_-_push-to-start_(2011-2013).rev-20140626.pdf from this site.

Installation appears to be functioning ... doors will lock and unlock via remote starter remote. I have the remote starter set to unlock before start, lock after start ... if the doors aren't unlocked before start, the OEM security system complains (horn honks... and honks). The doors unlock, the vehicle starts successfully, but when the remote starter attempts to lock the doors after start, all doors EXCEPT the drivers door lock... I can see the lever flip to lock on the drivers door, but then it immediately flips back to open again.

Would this have something to do with the A10 pin hookup on the evo all? ... the reference says it goes to the "driver door pin" ... but the illustration looks contradictory ... the expolded view of connector #4 on the vehicle shows a different pin location than the unexploded one. Maybe I have the wrong pin there? What is that supposed to do and how can I test if I have the right one selected?

Any help would be appreciated. I can't use it this way. Cheers.