Questions & Answers - Recent questions tagged clear-installation-instructions

I've installed my evo-nist1 per install guide #74301 and no start.

Tue, 18 Dec 2018 00:53:06 +0000

3X lock and the evo goest through a cycle, parking lights illuminate, brake lights illuminate, but no start. The more I attempt to research the issue the more diagrams I see with different wiring diagrams. Evo also flashes red three times upon completion of cycle. I have exhausted all options I could come up with on my own to resolve the issue, to no avail. Please help!

2015 Nissan Sentra SV push to start

2017 Dodge Journey Install Guide States I need a Resistor but I don't see where it's used?

Fri, 30 Nov 2018 10:29:12 +0000

I am reviewing the install guide #74201 and on the first page it states that the install requires 1 resistor. But it doesn't say what kind of resistor and the rest of the instructions never mention it. Also on page three the instructions show a wire location with the number 3 in which it states "passenger kick panel" but the image is showing the "driver kick panel" Can anyone clarify these install instructions.

issues with programming it to a 2013 f150

Wed, 07 Sep 2016 14:26:02 +0000

When programming the unit as a stand alone remote starter "lights red and blue on" i run through all the steps for using both keys but i never get the lights to flash on the unit. They stay solid red and blue the entire time.

Just to make sure i wanted to reset the evo-all but i cant figure out how to do that. I already have the data link and i flashed it to the recommended firmware 71.28.

I basically want it just for the remote start. I wanted to use the alarm features but i am so lost with the instructions. My kit came with the T-harness.

EVO-For.T1 not programming. Are all wires needed?

Thu, 17 Dec 2015 20:44:31 +0000

Just received a EVO-FOR.T1 for a 2010 Ford Fusion (automatic, key start). Have installed remotes before. Saw a You-tube video that showed installation of the four plugs on the ignition module and only 2 additional ones for Can-High and Can-Low on teh ODB-II socket. The instructions via the Fortin site (Addendum-Suggested wiring harness configuration - Guide 32161 Ver 20150428 was difficult to follow. I then registered and downloaded the Wire Color instructions (Addendum-Suggested wiring harness configuration - Guide 32221 Ver 20150428) which showed 5 additional wired connections (including a hood contact pin that wasn't part of the kit) and a need to cut a loop for automatic transmission (which wasn't on my Fortin module. It seems the module in the instructions is a EVO-ONE whereas I was supplied with a EVO-ALL.

So far, I followed the You-Tube showing the four connectors with the ignition module, and the Can-High and Can-Low. Although the You-Tube showed a successful programming cycle, mine did not turn on the ignition at the final step.

Do I need additional wiring? Do you have any clearer installation material for the unit I purchased? If not, how do I learn what I need to complete this installation.