/en/qa/tag/compustar-ft-d100 Powered by Question2Answer /en/qa/30683/ft-d100-evo-one-pinout-advice <p> I'm using a 6-pin Compustar antenna going into the FT-D100, which then connects to the EVO-ONE. &nbsp;Here is the connector going into the EVO-ONE: <br> <br> <img alt="" src="http://i.imgur.com/X7s7gid.gif" style="width: 250px; height: 376px;"> <br> <br> &nbsp; <br> <br> Question 1: &nbsp;Do I reverse the blue/white data wires? <br> <br> Question 2: &nbsp;Would you happen to know if the 2-pin connector (12v/ground) on the FT-D100 is required in when outputting to the EVO-ONE? <br> <br> Thanks again!</p> RF-Kits /en/qa/30683/ft-d100-evo-one-pinout-advice Fri, 19 Dec 2014 16:26:40 +0000 /en/qa/24313/what-does-it-take-to-install-the-drone-dr-3100-to-evo-all-used-as-stand-alone-starter Does the DR-3100 need the FT-D100 to connect to an EVO-All while using it as a stand alone remote start system? &nbsp;What protocol does the EVO-All need to be set on to communicate?<br /> <br /> &nbsp;<br /> <br /> Thank you for your time.<br /> <br /> Regards,<br /> <br /> Daniel J Glamann<br /> <br /> Shoclmann Audio Dodge /en/qa/24313/what-does-it-take-to-install-the-drone-dr-3100-to-evo-all-used-as-stand-alone-starter Tue, 18 Nov 2014 22:04:03 +0000