Questions & Answers - Recent questions tagged doesnt

Suzuki Grand Vitara 2010, Evo all doesn’t program

Tue, 08 Sep 2020 21:26:49 +0000

hi, I just installed an evo all with a remote start crimestopper rs4-g5 on a regular key 2010 Suzuki Grand Vitara, the problem is that when I am doing the programming, it never goes beyond the fixed yellow light, (step 5) when I put the key in on position, the bypass never changes from the yellow light, I never get to program it. (bypass Evo all 2020) I tried programming with both keys (2 keys) and with neither function.

Sn: 001A07 129726

My EVO One doesnt program

Sun, 30 Dec 2018 00:58:22 +0000

SO i bought the kit for the plug and play for remote start for my 2015 rav4 along with the T Harness. everything is installed correctly. I am running on the 79.49 bypass and 1.24 on the remote starter. it doesnt seem like it wants to go into the programming mode. i have held the buttion so the red and blue light stood soild than i plug in all the wires as followed by the instructions. it blinks 9 times and pause. i turn the ignition on but nothing happens please help.

2017 Ford Transit T-Harness does not fit.

Thu, 21 Dec 2017 23:12:09 +0000

hello, i am intalling evo-one remote start on my 2017 ford transit, i am using a t-harness " thar-ford1 rev.1 lot:50467" big 6/7 pin connecter fits right on the lock, but small 4 pin connecter for pod signal has no where to plug in, there is no other 4 pin connecter in streeting colum/ lock area. i used instaletion guide #31771 rev:20170303 which shows that small 4 pin connector should plug in on the bottom of the lock, but my vehicle doesnt have that connecter. How can i maka this work?

Or even if i use the regualar instalation guide "31771 rev:20171206 i need to find these two wires rx which is purple/grey and tx which is yellow/orange they should connect to a10 and a20 on the evo one. but my car doesnt have those wire colors. or the 4 pin connecter anywhere near the lock.

if so could i use the t-harness without the 4 pin connecter and just splice the two pod signals rx and tx, if i will find the wire colors for them.

help would be appreciated thank you.

EVO ALL GMT4 doesnt start

Wed, 19 Oct 2016 19:26:11 +0000

Key programmed correctly and updated firmware. Options D1 and C1 are on since I am doing standalone install. Doesn't start...leds on unit make me think its trying to remote start but it doesn't crank or start.