/en/qa/tag/evo-fort2 Powered by Question2Answer /en/qa/86994/evo-fort2-2018-ford-f-150-stx-ignition-power-no-start Programming successful except for final step. Vehicle power comes on but vehicle does not try to start. I see on the diagram there is a "rs6 in/out ignition +" coming from the yellow A1, I dont know where that wire goes besides to the T-harness. My vehicle seems to be activated by the Evo module, and won't allow key start once that occurs, and won't disable by pressing the brake. Any idea what I'm doing wrong? I did the can high and low taps at the odb, I have a factory hood switch, all light in the programming match instructions, until the point where it's supposed to turn on and then turn back off. Help!! Ford /en/qa/86994/evo-fort2-2018-ford-f-150-stx-ignition-power-no-start Tue, 26 Mar 2019 18:40:12 +0000 /en/qa/86710/do-i-need-a-flash-link-updater-for-the-evo-fort2-installing-on-a-2013-ford-fusion-with-2-keys i purchased an EVO-FORT2, and was under the impression that it came preloaded with the correct software for a 2013 Ford Fusion.  i used the evo-all with thar-for2 guide and it learned both keys but then says to hook up to a computer with the flash link updater.   my unit alternates between the yellow and red lights Ford /en/qa/86710/do-i-need-a-flash-link-updater-for-the-evo-fort2-installing-on-a-2013-ford-fusion-with-2-keys Sat, 02 Mar 2019 11:40:12 +0000 /en/qa/81766/problem-with-programming-keys-on-2017-f-150 I have an EVO FORT2 with T-Harness for an 2017 F-150. Going through the procedures with no problem until i get to programming my keys. When I insert my key and turn to ON/RUN, I get a red solid red light and flashing yellow light. This stays on until I turn the key to OFF, then I get an alternating red and yellow flashes. Please help. Ford /en/qa/81766/problem-with-programming-keys-on-2017-f-150 Sat, 06 Jan 2018 20:43:24 +0000 /en/qa/76486/can-heat-ac-be-wired-in-to-come-on-automatically-in-2013-ford-fusion I have a 2013 Ford Fusion SE, and I've installed the EVO-ALL (EVO-Fort2 package) unit and I'm wondering if there is an accessory wire in the white 20 pin supplied plug that can tap into the heat sensor on the lower kick panel to the right of the steering column? I've seen people do this on YouTube in the 2014-2015 Fusions with the same Fortin starter but it's never stated which wire to use with the supplied plug. Is this something that can be done or is it something in the options menu that needs to be turned on? Thanks Ford /en/qa/76486/can-heat-ac-be-wired-in-to-come-on-automatically-in-2013-ford-fusion Tue, 17 Jan 2017 08:48:20 +0000