2015 Tacoma with Evo One and RF642W start 2 seconds then stop and re-try again

Wed, 03 Feb 2016 11:39:45 +0000

Hi I need some helps please

I used guide# 19621 to install my Evo One into 2015 Tacom V6 and Auto-tran (with G-Key) using Toy2-Harness everything went fine, program Evo One and RF642W remote was fine. But the Truck only start and run about 2 seconds then it shut off and parking lights blink few times then it re-try to start second time cranking but engine won't start. I notice Immobilizer light was blinking the holl time during remote start, run and shut off, it seem IMO by pass is not working?

I re-check my connector twice from 20-pin connector and red-connector to ECM Blue/white and Lt. Green/black

Do I have to connect CAN wires (Gray and Gray/black) to OBDII connector? it did not mention in the guide at all.

I did connected Lock/Arm (Purle wire to vehicle Purple wire and Purple/white Unlock/Disarm to vehicle Green/black) work just fine. do I have to change any settings at all to get it going? I did update firmware to the lastest one on both Evo one and Remote start.

Here is what I have set FORTIN EVO ONE (2015 Toyota Tacoma V6, Auto-Tran)
Bypass firmware 79.34 - below is things that are ON

A1- Door locks
A3- Key Bypass
A7- Foot-Brake (output status)

B1- Unlock Driver Door Only
C1- OEM Remote Monitoring

Remote-starter firmware 1.16 Set as the following:
2.4 Configure main harness outputs as: White: (+) Start, Orange: (+) Ignition2, Pink: (+) Ignition, Yellow: (+) Start2.
3. Tachless sensitivity: 1
4.1 Remote car starter runtime: Gas: 15 minutes
6.2 Door Lock before and after remote-start: Unlock before remote start and lock after remote start
7.1 Safety locks: NONE
8.2 Unlock pulse time: Double 0.25 sec pulse
9.1 Active or Passive Starter Kill: Active. Press LOCK to activate the Alarm and starter-kill.
11.1 Confirmation: Silent on 1^st LOCK/UNLOCK press. Sound on 2^nd LOCK/UNLOCK press. Antenna LED active.
12.1 Sound Confirmation: Horn only. Output programmed to be used for vehicle horn
13.2 Pulse Confirmation: Short
14.1 Alarm and Starter Options: Alarm Disabled, remote starter enabled.
15.1 Smart door lock: Disabled
16.5 Cold start timer: Cold time OFF
18.1 Diesel mode: Disable
19.1 Turbo mode: Disable
20.2 Engine Supervision: Tachless only.
21.1 Start attempts: 2 times
24.4 Special Applications: Application 3. Turn OFF the engine when the foot-brake is pressed.
25 OFF
26.1 Hybrid Mode: Gas/diesel vehicle
29.1 Alarm duration: 30 seconds.
30.1 Valet Code: Ignition ON + 3x valet button
31.1 Special application programmable output: Disable
32.1 Ground out: Shut down 1s after remote start run time. Dark Blue wire (ground out)
33.1 Manual transmission ready mode activation: Activated by remote starter remote. Ready mode activated with the starters remote
34.1 Trunk output: Pulse 0.5 seconds
35.1 Door lock special application: Disable
36.3 Activation/Deactivation remote Valet mode: By valet button only
37.1 Security remote car starter special application: Disable
38.2 System control by OEM remote: Enable (press 3x lock to remote start (bypass module required)
39.1 Temperature control: Disable

Robert Saing

Questions & Answers - Recent questions tagged evoone-toy2-fr642w-g-key

2015 Tacoma with Evo One and RF642W start 2 seconds then stop and re-try again