Questions & Answers - Recent questions tagged gas

2009 Dodge ram, I looked at the guides and install going by them but all i get is all 3 leds flash

Sat, 30 Jan 2021 20:58:14 +0000

Please help frustrated

Can not proceed Page 6/10 (dcryptor programming procedure). when i apply the step 4 in page 6/10 the Blue LED turns off

Tue, 10 Nov 2020 07:13:10 +0000

I've updated module Evo-One for my Audi A5 2011 Gas with key-port before the installation and now can not proceed Page 6/10 (dcryptor programming procedure). when i apply the step 4 in page 6/10 the Blue LED turns off which makes unable to continue the step 5.

2019 RAM 2500 Push to start GAS blue light goes out after plugging in the 20 pin con (step 3)

Thu, 26 Dec 2019 15:59:17 +0000

2019 RAM 2500 Push to Start GAS

(What I wired)

THAR-CHR6 Harness: I wired from the EVO ALL A1 to the purple and white on the Igintion BCM module. A10 to Lt.Blue of T harness, A20 to the Lt.Blue/Black of T harness, with an OHM meter I ringed them out (they are connected). I tied the red connector D3 & D1 together and soldeir together at the T harness as discribed. Can 1 LOW connection C4 from the EVO to the Yellow of CAN 1 connector on the truck. Can 1 High connection C3 from the EVO to the Brown and White of CAN 1 connector on the truck.

(plugged it the remaining plugs by the steps discribed into the EVO ALL)

Issue I have: I go though steps 1 & 2, however when I plug the 20 pin connector in the light the blue light goes out. (no lights are on).

I updated and flashed the EVO to Firmware 74.[38] Hardware inside 7.0 however, the the orange box says Recimmended firmware is not loaded 63.[02] then there is a green Update to that version aside it.

What can my issue be. Thank in advance for any help!

Why do I Get U0001 code. Evo chrt6 on 2018 Ram 1500 gas standard key. Everything works fine.

Sat, 29 Dec 2018 19:31:14 +0000

U0001 code 2018 Ram 1500