/en/qa/tag/guide-error Powered by Question2Answer /en/qa/81404/error-in-guide <p> Is there a problem with guide (34911 Rev. 2060914, 2014 Kuga PTS ATM, evo-all FW 71.35 and 71.44) or am I doing something wrong?</p> <p> Problems begin from step 6:</p> <div> 6. Press and release the Push-to-Start button to turn ON the ignition.&nbsp;</div> <div> The YELLOW LED will turn on.The RED LED will turn OFF.</div> <div> &nbsp;&gt; In my case yellow led turns on but red doesn't turns off by itself. It turns off only when I tap the brake pedal.</div> <div> &nbsp;</div> <div> 7. Press and release the Push-to-Start button once to shut off the ignition.</div> <div> 99The YELLOW LED will turn OFF. The RED LED will turn on.</div> <div> &gt; This time everythings ok</div> <div> &nbsp;</div> <div> 8.&nbsp;Press and release the Push-to-Start button to turn ON the ignition.</div> <div> The YELLOW LED will turn on and off.The RED LED will turn OFF. WAIT, the BLUE LED to flash rapidly.</div> <div> &gt; Now red doesn't turns off and no yellow (waited 1 minute). Then I tapped brake again and red goes off, yellow blinked one time and after that blue flashes rapidly.</div> <div> &nbsp;</div> <div> 9. Is ok - red and yellow alternates.</div> <div> &nbsp;</div> <div> Is it possible that this additional brake tapping causes key to read abnormally? Because after all this actions Decrytor worked without errors but after trying to remote start I see "Key doesn't recognized" and car can remote starts only when I place FOB near driver's window.</div> <div> &nbsp;</div> <div> P.S. One more problem with wires in guide is that A17 &amp; A18 are swapped. If I connect them by guide - car can't lock doors because it "thinks" that door doesn't closed firmly.</div> Ford /en/qa/81404/error-in-guide Tue, 19 Dec 2017 04:44:36 +0000