/en/qa/tag/infiniti-ex35 Powered by Question2Answer /en/qa/67728/ex35-evo-nist1-and-t-harness-wont-remote-start-without-foot-on-brake I have a 2008 Infiniti EX35 PTS with the EVO-NIST1 and T-harness installed for a standalone remote start system. I used the most current firmware, turned on D1 and C1 options, and the module was successfully programmed. The vehicle will not start with the 3x lock signal, it will only go to on and then acc modes. In troubleshooting, I pressed the brake pedal and then tried the 3x lock which started the car. Further, I tried switching the RL1 to RL2 connector, but this did not work. Next I put a voltmeter on the white/red wire on the brake connector harness, during the startup sequence the voltage seemed to be constant but only 11 volts and occationally dropped to 0 during the sequence. I re-installed the firmware and reprogrammed the EVO again to make sure there wasn't any issues, but it still work work. Do I have a bad EVO, harness, or something else? Infiniti /en/qa/67728/ex35-evo-nist1-and-t-harness-wont-remote-start-without-foot-on-brake Tue, 19 Jan 2016 09:59:40 +0000 /en/qa/7013/2008-infiniti-ex35-no-crank Im using an EVO-ALL with remote start. The unit powers up, but the push button only advances to ACC, almost like the white/black wire isn't triggering it to the IGN position. This makes it a little more wierd, If I hold the brake during remote start it WILL start but then dies after 5 seconds. Yes, I have checked that I am on the correct 12volt and Brake wire, and metered the brake wire during crank and it is being powered up similar to ignition or +GWR. I have checked through all my other connections all ready. Any input would be appreciated. Infiniti /en/qa/7013/2008-infiniti-ex35-no-crank Fri, 20 Dec 2013 13:00:15 +0000