Questions & Answers - Recent questions tagged infinity

'12 G37 - Is my EVO-ALL broken?

Fri, 18 Oct 2019 20:56:21 +0000

[EVO-ALL install on 2012 Infiniti G37 w/ THarness; SN/001A07 008704; Guide #80851]

Issue:

Cannot program the EVO-ALL. I get stuck on step 2. When I press the button twice, the yellow LED doesn't start blinking.

In addition:

1) I noticed if I remove the data link cable from the EVO-ALL while the white 20-pin connector is installed, the locks contantly go off (always locking).

I have gone over the wiring many times and am confident it's correct.

2) During step 1, I have to disconnect and reconnect the data link cable several times before it finally begins cycling through the LEDs.

Is this normal? or is it asign of bad wiring? bad unit?

2009 G37 EVO ALL NOT WORKING AFTER FLASH

Sat, 09 Feb 2019 19:35:32 +0000

1) I Installed EVO All and Tharness (programmed EVO while hooked up to harness in car > Evo lit up blue when pushing lock but car would not start using oem remote. (Learned I needed flashlink)

2) Bought flashlink 4 and updated and flashed EVO All

3) Reinstalled EVO All and ZERO lghts came on and car did not start

I followed recommended settings:

A1-11 ALL ON

B2 OFF

C1 & D1 ON

D2 ON

After flashing the EVO I depressed the program button and no lights come on. I plugged it back into the wiring harness and again, no lights. Before I flashed it the red light would come on while depressing the button...what could have happened?

FRUSTRATED!!!

2009 Infinity G37 OEM remote No Start

Mon, 04 Feb 2019 19:57:01 +0000

I just finished installing the EVO-NIST1 (no other components) on my 2009 Infinity G37. After hooking up the wiring harness I completed the bypass programming procedure and everything went good until I tried to start the car using my OEM remote. I pushed my OEM remote 3 times and the car did not start. Each time I pushed the lock button a blue LED light flashes on the EVO unit but nothing else happens. Do I need to order a stand alone remote? Do I need additional components? Not sure what to do here.

2011 Infinity QX56 Programing EVO-ALL & THAR-NIS1 Stand Alone

Sun, 31 Jan 2016 21:40:25 +0000

Car 2011 QX56

EVO-ALL & THAR-NIS1 Stand Alone Service # 001 A06 585175

Guide #12681

During programing when I get to #7 The red sometimes turns off and only blue is on. I have only been able to get both red and blue to stay on twice very briefly.

In the instances when they stayed on, following the next step #8, Pressing the start and stop button x2 does not turn on the ignition. If you press it a third time or jump to #9 the the inginition turns on and it flashes rapidly. If I go continue with the programing, the result is that the car does not remote start on pressing 3 times. Basically nothing happens, it simply locks the door 3 times.

I have an updated firmware. Did the update all over again yesterday successfully. I have been on this thing for the past 2 days. Have not done anything else all weekend.

I am at my wits end with this thing. Somebody help.