/en/qa/tag/no-red-flashing Powered by Question2Answer /en/qa/85012/2012-elantra-touring-no-red-led-flashing-during-programming When completing step 4 RED LED doesnt flash, it stays on solid with the YEL LED after BLUE flashing 15x. CANBUS wires read 2.35V(Low PIN 6 OBDII) and 2.75V(high PIN14 OBDII). All other connections verified and appear correct. Hyundai /en/qa/85012/2012-elantra-touring-no-red-led-flashing-during-programming Tue, 20 Nov 2018 10:46:47 +0000 /en/qa/83951/red-led-comes-blinks-during-programming-blue-turns-off-light-data-wire-obdii-confirmed-connected No red led comes on or blinks during programming.  Blue turns off, no red light.  Data wire to OBDII confirmed connected GMC /en/qa/83951/red-led-comes-blinks-during-programming-blue-turns-off-light-data-wire-obdii-confirmed-connected Wed, 12 Sep 2018 19:24:08 +0000 /en/qa/80501/2010-fusion-getting-solid-red-led-but-no-yellow-led-when-in-on-position to start off im not really a car guy but this seemed pretty easy but anyways i just went to install the EVO-FORT1 into my 2010 Ford Fusion Sport and i put the data pin in and get the solid blue LED then go back and plug the red plug in and get the solid red LED. after all of that i go to put the key into the on postion but it stays solid red. i am asummng that it has something to do with the other plugs that has all the wires on the end? Ford /en/qa/80501/2010-fusion-getting-solid-red-led-but-no-yellow-led-when-in-on-position Sat, 28 Oct 2017 12:39:04 +0000 /en/qa/80500/during-programming-of-evo-all-no-red-blinking-after-ignition-on-only-blue-light-blinking all connections double checked including light blue/black to key data(ems com). i did cut the wire to see if engine will not start-and it did not start after cutting. that confirmed im on the correct wire. Hyundai /en/qa/80500/during-programming-of-evo-all-no-red-blinking-after-ignition-on-only-blue-light-blinking Fri, 27 Oct 2017 21:11:39 +0000