Questions & Answers - Recent questions tagged off

Red light disappears and Blue light stays solid

Sun, 05 Jun 2022 02:22:04 +0000

Hello, I have a 2015 Infiniti Q70 and when i program the module, I can get up to step 8 without any issues. When I press the brake for the second time, the red and blue light comes on, but after about 1 second, the red light disappears and the blue light stays solid. I'm unable to complete the programming of the module. Verified all connections are tight and correct. Please help!

2012 dodge avenger with evo-chrt5: it remote starts but then shuts off and starts again and then stays running

Mon, 13 Sep 2021 23:51:06 +0000

2012 dodge avenger with evo-chrt5 w t-harness

it remote starts with key fob but it shuts off right away and then starts again and stays running.

i did update the softeware and i did program it correctly i believe

Vehicle does not stop when key is removed or brake applied or 3X remote pressed

Wed, 11 Nov 2020 16:17:29 +0000

2007 Jeep Compass.

Installation was successful. Evo-All and THAR-CHR5

4 days later car would not shut off. Key removed, brake applied, remote activated 3x. No shut off.

I had to unplug the Evo-All for the car to shut off.

I plugged Evo-All back in and I could only get a flashing Blue light. Not able to use Evo-All. I currently have the unit removed and using key only.

Radio stays on after vehicle times out or is shut off

Fri, 16 Oct 2020 08:24:37 +0000

When evo-all times out and engine shuts down the radio remains on

2013 Toyota Venza takeover?

Sat, 29 Aug 2020 10:43:51 +0000

I have Evo All hardware version 6 latest firmware, when I open the door the vehicle shuts off, is takeover available?

2016 Toyota Corolla Evo One

Mon, 24 Aug 2020 18:41:19 +0000

I have used the Toy 8 Harness that came with the Evo One,Module (TOY 8 79/xx/1.xx C1, D5 38.2 Progam Lock).

I followed all the steps and when I plug the 20 Pin Connector in the Evo Module, the noise sounds and the dash board warning message says, TURN LIGHS OFF and when I try to Press the button 10 times, the RED and BLUE LEDs fade out by the time I get to 6.

I can't get Pass Step 3!

I reset it a few times and still the same thing!

I switch the Pins and try to use it as a TOY 3 Harness and the same Thing!

I even Hard Wired the module using the Diagram and still the same thing!

I'm thinking this was a bad Module from the beginnig!

I have listen to TECH Support ideas and tried them and nothing works!

I've made 7 attempts on wire this Evo One, trying different ways and the Module keeps doing the same thing every time.

I'm ready to give up!

Any idea, why this Warning Light coming on?

Do this warning light be the reason why I can't ger pass Step 3?

2016 Toyota Corolla with H key,

Wed, 19 Aug 2020 18:19:25 +0000

After following the diagram and I go through the steps!

When I go to plug the 20 Pin connector in the EVO ONE, it makes a noise like the lights are left on and the Dash Board warning say's TURN LIGHTS OFF!

When I unplug the 20 Pin connector, the noise goes awayand the dash bord warning for TURN LIGHTS OFF, goes away!

I try to program the EVO ONE Module with the noise and TURN LIGHTS OFF, by pressing 10 times, the light stop around the 5th to 6th press and it won't let me get pass Step 3.

I reset the Module and did and Master rest and still have the same problem!

2013 Toyota Tundra starts for a few seconds then shuts off

Sat, 11 Apr 2020 21:18:55 +0000

I have tried everything. I am pretty sure it's programmed correctly. It starts then shuts down seconds later. I am all out of ideas and ready to give up. Service number 002BO7 339682

2013 Tacoma Evo one lights won't turn off after time out until doors are opened

Thu, 14 Nov 2019 07:07:25 +0000

Everything work except when remote starter times out the lights stay on and wind go off unless the door is opened

I can switch off while driving

Thu, 03 May 2018 13:06:16 +0000

Hello

Is it normal to be able to turn off the car while im driving? becaus I can now !!!!!

another issue :

when I start x3, the yallo and red light goes on for 7 min, then if i drive for 5 min and stopped, the car will shut off but wont if im driving. is this normal?

Service No: 001A06 754622

Installed EVO- ALL, now I can switch off the car while driving !!!

Sun, 21 Jan 2018 00:27:25 +0000

Hi

After installing evo- all, I am able to switch off the car by PTS while driving. This is a security issue. the car never switches off while driving but now, I can.

How to fix this please?

nissan maxima 2014

Opel insignia start and shut in 1 sec. Egual at buick regal 2014

Wed, 17 Jan 2018 03:24:07 +0000

I have programmed and installed, the car when pre 3x lock start, led go red, after yellow, after stop engine and red flash 2 time yellow turn of, and retry automatically the second time to start engine, this run, red and yellow power on, after shut off nd red flash one time. What i need to do? What is the problem? Standard key.

https://www.youtube.com/watch?v=XOidPkUg9aY

Unable to shut vehicle off with 3X lock remote start

Tue, 09 Jan 2018 08:40:26 +0000

2013 Honda Accord with PTS. Starts great, but unable to cancel during run time cycle.

Vehicle doesnt shut off unless the lock 3x is used or timer runs out. 07 ford edge

Sun, 29 Oct 2017 19:24:37 +0000

I followed the install instructions and programmed with two keys, and the it'll start, but I either have to way until the timer runs down or hit lock 3x. 2007 ford edge with evo all standalone.

Vehicle does not switch off when key is removed

Sat, 02 Sep 2017 19:04:51 +0000

Just finished installing EVO ONE with THAR ONE HON2 t harness. Enabled C1 and 38.2, programmed and the vehicle starts with 3x lock. However when placing key into ignition turning to on and then turning off the vehicle continues to run until the 15 minute timer passes. I can press lock 3 more times and it shuts off. If I leave the key in the run position and wait longer than 15 minutes the vehicle will stay running and then shut off with the key.

Am am I missing a setting?

Also as a result the EVO keeps the parking lights on during the 15 minutes even with key on and this causes the auto headlights not to function until the 15 minutes has passed. Probably related to the system not switching over to the vehicle ignition as well.

Lights stay on even when car is off!!!

Mon, 06 Feb 2017 12:20:36 +0000

Bought the Fortin Evo for the max...flashed it...everything works but when the car is off and locked, all interior lights including the outside factory courtesy lights stay on! Any suggestions?

Installed and alarm goes off ever time i start with push start do i have to unplug the evol and put in computer again

Wed, 11 Jan 2017 22:24:06 +0000

Alarm sounds after i push auto start button honda accord 2013

Altima 2012 - Car Not Shut Off from long distance but Starts

Sun, 31 Jan 2016 11:38:12 +0000

Hi, I just installed EVO-NIST1 as per Installation Guide in my Nissan Altima 2012 (Push to Start - Auto transmission) for using my OEM Key Fob to Remote Start and OEM Key Fob to Remote Shut Off.

Note : Flashed with the Latest Recommended Firmware for Nissan Altima 2012. Configured first Mode (Remote Starter) - Options enabled (A1,A2,A3, B1, C1, D1, D1.6, D2, D5, D6)

Also configured mode bypass with same options mentioned aboved.

Ever things works as it should be,

From Distance (car) 1-8 meters when I press lock button x 3 times (OEM Fob key) car starts and when I press lock button x 3 times again car shut off.

From Distance (car) 10-30 meters when I press lock button x 3 times (OEM Fob key) car starts and when I press lock button x 3 times again Car NOT SHUT OFF. Until I walk in distance under 8-7 meters to car than if I press lock button x 3 times Car shut off.

What I don't understand if I've a problem with OEM Key Fob distance limitation than how come I able to Start Car from long distance ( 10-30 meters) but at same distance Not able to shut off.

Help me out with this issue, is there any optin that I need to enable or disable ?