/en/qa/tag/programming- Powered by Question2Answer /en/qa/98819/blue-light-never-flashes I have a 2020 ram 1500, tip key , gas model truck. When following the directions I get to step 7 which is where I get the red and blue lights when inserting the key but then my red light goes off where it should stay on and the next step completely fails as the blue light just goes out and does not flash when it should. Anyone have the answer to this issue or is there another wire that needs to be hooked up other than my 2 can high and low and yellow to ign? Ram /en/qa/98819/blue-light-never-flashes Wed, 14 Oct 2020 17:30:20 +0000 /en/qa/81231/no-flashing-blue-light-during-programming I have a 2013 Kia forte. I Installed the evo one using thar-one-khy1 t-harness. I have programmed both the remote start and bypass sides of unit but i do not get a flashing blue light during programming through can bus. When I turn key to on the blue light goes out and doesn't flash. I have verified that i have the can wires correct. They both show 2.3v. Vehicle does not have pats data wire or immobilizer Kia /en/qa/81231/no-flashing-blue-light-during-programming Fri, 08 Dec 2017 20:33:28 +0000