Questions & Answers - Recent questions tagged rap

Remote start status (eg. Wiper Interrupt) when GWR (Dark Blue A8) is configured for RAP pulse per Function 32 Mode 3?

Thu, 06 Aug 2020 21:49:57 +0000

Product: EVO-ONE
Vehicle: 2010 Toyota Tacoma (Standard 40-bit Key)
Configured per Fortin application note

I am looking for a signal (negative or positive) to indicate that the EVO-ONE has remote started the vehicle and that it is currently running. Ultimately looking to slave features such as wiper inhibit, defrost, etc. I understand that the Dk. Blue A8 "GWR" configured as Function 32 - Mode 1 or Mode 2 would be exactly what I need however I am required to configure GWR as Mode 3 for "Autolight shutdown" per the installation guide for my vehicle. I haven't looked at the signal with a scope or logic analyzer to confirm but it sounds like it will pulse ground only at the end of the remote start run but otherwise float high impedance.

I have scoured all documentation I can find but am wondering if there is another pin which may have an undocumented setting or alternative function which could be used for this?

I suppose in this case, I could force GWR line back to Mode 1 and then program a microcontroller to then mimic the RAP signal needed for Autolight shutdown -- but -- hoping there is a trick I am missing.

2005 Chevy colorado, RAP. While remote started the driver door trigger is staying engaged.

Fri, 17 Jan 2020 23:04:32 +0000

This causes the door not to be able to be locked. It locks then unlocks because the truck thinks the key is in anf driver door is open. Also the radio stays on after remote shutdown.

How do I disable seat memory settings

Sun, 17 Feb 2019 16:13:40 +0000

Is there a way to disable seat memory settings prior to entering the car? When I open the door the seats move into the preset position. Ideally it would be better if the seats would move AFTER I've entered the vehicle and closed the door.

Reggie Brown

Do I need to Turn On D7 Rap Disable For door pin connection.?? or just leave it off.

Wed, 19 Dec 2018 21:02:51 +0000

Is D7 Rap Disable, Need to trun ON for rap shutdown. on 2014 nissan murano

2016 Fusion RAP stopping when engine is shut off remotely or times out not working

Thu, 25 Oct 2018 02:13:27 +0000

2016 Ford Fusion, Standard Key, EVO ONE with T Harness. All connections made including those listed as optional. Relay used for Parking Lights, Driver Door Pin on pin 33 of BCM green violet to A17 ... A18 as per instructions. No T Taps - everything soldered. Remote start functionality fine. With the RAP connection the voltage from the auto's bcm side is 10v not 4 or 5. If I start the car with the remote, let it run one minute, hit the start button again to shut the engine off, the parking lights stay on 2 mins and the radio stays on for 10 minutes. I timed them. Also if I let the car run 15 minutes and essentially time out, the engine shuts off but the radio and lights stay on for 10 minutes. I was expecting the radio to shut off instantly just as if I had open the drivers door. Look forward hearing comments.

2010 MKX - PATS failure, no RAP

Thu, 16 Mar 2017 01:21:46 +0000

PATS failed to program with 2 key method, tried Dcryptor it failed too. Now all 8 key slots are full and vehicle locked out key programming.

Also RAP does not work. Verified GRN/WHI to door side and GRN/RED to VEh side. Tested wires with meter, they are closed circuit and never change state.

how to turn off radio after remote start turns off. 2014 f150

Thu, 31 Mar 2016 21:48:26 +0000

I want to know if there is a way after 15min the vehicle turns off can the radio turn off or do I have to let it say on for the 5min factory setting.