Questions & Answers - Recent questions tagged red-led

Evo-all standalone module stuck on red light resets will not work

Wed, 19 Feb 2020 10:51:04 +0000

Remote start evo-all standalone install for 2017 Nissan Armada

FAQ: RED LED STUCK ON

Thu, 14 Nov 2019 16:25:10 +0000

When a module is stuck on the RED LED.

flash version 0.99
disconnect unit from the flasher and power cycle it in the car (connect/disconnect power connector)
connect module back to the flash link and flash whatever firmware you need
Turn settings protection OFF if it's on and SAVE the options.
Reset the unit following the reset procedure. (this cannot be done while module is connected to the flash link) : https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193
Connect module back to the flash link and enable required options.
Reprogram module to the vehicle following instructions in the installation guide.

Reasons this happened.

Unit was connected WHILE doing the install.
Unit was disconnected during CAN programming before the blue led started to flash.
Power was disconnected while all other connectors were still connected.
during an update or save of options, the flash link lost connection to the module or the internet
RF protocols not setup correctly, or RF device not paired to unit correctly.
Datalink protocols not setup correctly.
Bad ground.
Loss of power during writing of data to the module.

Kia forte don't crank exterior lights flash

Sun, 06 Dec 2015 16:42:10 +0000

When pressing on the remote the exterior lights flash like the car would like to start but nothing happen. Constated that the 3 light of the fortin coupe dosen't light, except the yellow light of the ignition when key is on but engine off. The only information I got from the troubleshoot was the verify the power ground of the module, ground and 12v is there.

All other options work fine on it. Saw three fuses under the dash and nothing blown. Need more infos the continue troubleshoot thanks.

The module installed is fortin evo-all

-Eric