/en/qa/tag/renegade Powered by Question2Answer /en/qa/140388/2017-renegade Hello. When I'm programming the Evo-All on a 2017 Jeep Renegade, the blue LED starts blinking after 5 seconds (after pressing the button), and after turning off the ignition, the red LED stays on continuously. I've already tried it on two modules. Jeep /en/qa/140388/2017-renegade Fri, 12 Jun 2026 21:22:01 +0000 /en/qa/138058/2020-jeep-renegade-remote-start For information. I installed Evo-ALL on a 2020 Jeep Renegade. I specified the Jeep Compass in the manager. It only took CAN-1...I took CAN from the lower connector behind the BCM. From the thin green and brown wires. I took the parking light line back to the place where it was indicated on the previous model. Programming required opening the ON switch 10 times, as written in the manual. The PTS line was blue. The data line was yellow-blue. Jeep /en/qa/138058/2020-jeep-renegade-remote-start Mon, 12 Jan 2026 08:36:40 +0000 /en/qa/101449/2020-jeep-renegade-push-to-start-anyone-tried-it-wont-program 2020 Jeep Renegade Push to start. Anyone tried it ? The cables and connecters are exactly the same as a 2018 guide Programming wouldn't pick it up on an EVO ALL + CHR6 Jeep /en/qa/101449/2020-jeep-renegade-push-to-start-anyone-tried-it-wont-program Wed, 06 Jan 2021 14:48:35 +0000