Questions & Answers - Recent questions tagged stand-alone-options

What is the Remote Starter run time

Thu, 26 Dec 2013 13:34:51 +0000

How long will the car run before it shuts off when remotely started with teh evo all? All previous remote starters I have used have been around 15min run time9 8then they shut down.

Output for horn (honk) from EVO ALL as standalone?

Fri, 13 Dec 2013 14:17:20 +0000

We've done a bunch of Toyota/Lexus using the EVO ALL as standalone remote starter and it works flawlessly (except the whole no key take-over part, which is inconvenient).

My question is that... these vehicles have a separate siren/speaker (very low volumed beeps) for the lock/unlock confirmation. Is there a way for the EVO ALL could produce a momentary neg output that could be connected to the horn when the lock button is pressed in order to provide a louder audible confimation that the lock signal is being received by the vehicle? A customer just commented on how this feature will be very useful

This is not an issue for the Chrysler or the Fords since their factory keyless entry lock signal is connected to the horn already.

Can not remote start '07 Dodge Ram 6.7L

Mon, 18 Nov 2013 18:07:53 +0000

Installed Evo-All stand alone on '07 dodge Ram 6.7 diesel in accordance with THAR-CHR5 connection "C". and program 1. It unlocks doors, lights up the dash, locks the doors, the dash shows Check Engine light and the Evo-All has a red and amber LED. I have to disconnect the 4 pin Data link to get the truck to start with the key.

The unit was flashed to 74.08, options 12, 15,15.4 and 18 are on.

Any suggestions on whare to go next?