Questions & Answers - Recent questions tagged step-5

Can't complete Step 5 - Blue LED don't Flash. Audi S4 2014

Tue, 20 Dec 2022 16:17:44 +0000

Anyone can help me?

I'm Stuck on Step 5 while programming my EVO-ALL with the T-Harness EVO-AUDT1 on My Audi S4 B8 (2014).

The BLUE LED doesn't begin flashing.

CAN Connections are Good. I Measure round about 3V on the Whit 5 Pin connector between Grey and Grey-Black.

Grey-Black goes to Orange-Brown (CAN-Low) and Grey goes to Orange-Green (CAN-High) like in the Guide described.

I have connected these Cables at the CAN Connector near the Relays at the left bottom under the Driver footwell.

S/N: 001A06905491

Thanks!

Blue light won't flash in step 5 in guide 65321

Tue, 22 Mar 2022 19:54:31 +0000

Hi On my 2012 vw jetta manual transmission push to start. I connected everything it told me to connect on the wiring diagram but when I turn the ignition on the blue light turns of but won't flash Please help

Blue light never comes on

Mon, 08 Feb 2021 20:50:18 +0000

I get to step five re-insert the key in the red light stays on the blue never comes on at all. I have a 2017 Ram 1500 key start.

2020 Ram 1500 Push To Start, Blue light does not flash on step 5

Fri, 23 Oct 2020 11:04:01 +0000

While on step 5 the blue light does not flash. Once the button on the eval all is pressed the solid blue light goues out but the blue light does not flash as indicated in step 5.

The unit has been flashed to latest firmware 63.01.

Wires are connected per the chart.

2015 RAM 1500 Push to start never gets to step 5 (Stays solid yellow)

Wed, 29 May 2019 21:37:16 +0000

I have completed a master reset, and programming just the CAN-BUS works properly. When pressing the ignition button (push to start) the unit never goes red. (The documentation that came with mine shows a keyed unit, so I'm going by another guide I found saying to hold the fob up to the push-to-start button and push it twice.)
I have reprogrammed the unit a number of different ways (including everything off but the two 'recommended') and still no luck. Right now I have A3 A7 D6 as the only ones enabled and it still just stays yellow.
Thanks!