/en/qa/tag/stuck-on-yellow Powered by Question2Answer /en/qa/91643/yellow-led-stays-on-car-wont-remote-start 09 Subaru Legacy with evo one, standard key and manual transmission. All of the wires are installed and I followed the procedure for the dcryptor programming successfully, however I haven&#039;t been able to remote start the car. When I try to do the procedure (foot on brake, pull hand brake, release foot brake after 1 second) that&#039;s where I get stuck, holding the start button for 3 seconds does nothing for me, the parking lights don&#039;t flash or do anything. All of the functions of the remote work fine I can lock and unlock the door I have no issues starting the car with the key or anything. The LED on the unit remains yellow no matter what I do t&#039;s my understanding it should be flashing blue when I press buttons. I have already changed over the settings with the flash loader for manual transmission but still no luck.<br /> <br /> &nbsp;<br /> <br /> can anyone help me figure this out. Subaru /en/qa/91643/yellow-led-stays-on-car-wont-remote-start Fri, 08 Nov 2019 18:59:50 +0000 /en/qa/87585/2015-ram-1500-push-to-start-never-gets-to-step-5-stays-solid-yellow I have completed a master reset, and programming just the CAN-BUS works properly. &nbsp;When pressing the ignition button (push to start) the unit never goes red. &nbsp;(The documentation that came with mine shows a keyed unit, so I&#039;m going by another guide I found saying to hold the fob up to the push-to-start button and push it twice.)<br /> I have reprogrammed the unit a number of different ways (including everything off but the two &#039;recommended&#039;) and still no luck. &nbsp;Right now I have A3 A7 D6 as the only ones enabled and it still just stays yellow.<br /> Thanks! Ram /en/qa/87585/2015-ram-1500-push-to-start-never-gets-to-step-5-stays-solid-yellow Wed, 29 May 2019 21:37:16 +0000