Where to start?

Thu, 31 Oct 2024 19:47:29 +0000

Ok, fighting this thing for months. I bought a new module, programmed it, installed it, get the same no start as I did with old unit. I took the new one and reset. Reprogram and tried again and still nothing. I can't even get it to allow me to program the remotes to test the start function. So pulled it out, put the old one in and it tried to start after I pulled the OBD wire. Plugged it in and it started and ran for a few minutes and I tested everything. Great it works again...next morning, doesn't work. Single light flash and nothing. I started it with the key, did a remote start transfer and it took over. I pulled the key out and it stayed running for about a minute, then stopped. I tried again, nothing. So after 8 hours, I tried to remote start and it did, ran for about 10 seconds and shutdown. What's going on? Do I have a wire gremlin on the vehicle side? I disconnected all the harnesses wires, plugged them all back in and still nothing. Is there an alternative wiring?

EVO-ONE after 1,5 years stopped

Thu, 28 Sep 2023 06:41:49 +0000

After just over a year and half, and just less than a week ago it was working fine, my remote start no longer works. It acts like the vehicle battery is dead. I have checked the module, red led comes on, then yellow, then everything off like dead battery. If I pop the hood, it says not ready. Door open, not ready. So it tries but fails. Vehicle battery is fine, and vehicle starts fine with the key. Do I need to reflash the module? Defective module? Vehicle battery to low? 2004 Chevy Suburban 2LT Standard Key.

Lock, unlock, panic all work. I also have RFK4411 remotes. Same issue no matter which remote is used.

This is a video:

https://youtu.be/_jvPEv49Gbo?si=5QQzIXTqbi71WNgC

Questions & Answers - Recent questions tagged suburban

Where to start?

EVO-ONE after 1,5 years stopped