Questions & Answers - Recent questions tagged tele-connect

Tele-connect + horn wire??

Wed, 15 May 2019 14:13:36 +0000

Hi I have a 2017 Subaru Legacy(standard key) with Evo-One and I’m going to install the Tele-connect device

and on the manual step2 to connect yellow wire to positive horn wire but the evo-one is already connected to the negative horn wire, do I still need to connect the yellow wire from the tele-connect to positive horn wire?

i tried searching where/what color my cars positive horn wire but couldn’t find it.
Also if I connected the horn wire from tele-connect do I need to disconnect the horn wire from EVO-One?

thank you

MyCar Telematics starts then turns off after a few seconds

Thu, 27 Dec 2018 17:57:05 +0000

Vehicle: 2011 Toyota Corolla S (G-Key), manufactured in CAN.

Evo-One w/T-harness installed and working properly using OEM remote (3x lock to start).

When trying to start vehicle via the MyCar app, the engine will start and as soon as the doors auto lock the engine will shut off.

I have installed the MyCar Controls telematics unit based on the guide here: http://cdn02.fortin.ca/download/64631/autolink-install-guide-64631.pdf#page9

I used the HRN-LLRS-01 connector as instructed.

“Fortin 2” selected in RF section of configuration tab in FlashLink Manager.

MyCar Controls app Device Protocol: Fortin

Please help!

Cannot Learn MyCar Telematics Module - Evo-One

Sat, 17 Mar 2018 11:07:01 +0000

I am trying to learn/teach the Evo-One the MyCar Telematics module. I have followed the directions and preconfigured the Evo with the Fortin 2 option.

I cannot get the Evo into programming mode. I turn the Ignition to ON hold the button (next to loop) on the Evo for 5+ seconds as the instructions say, but the led never changes to red and remains amber. Any suggestions?

I should also note that my install was done using all T-Harnesses so I know I don't have any wiring issues. I tested the Evo for functionality before moving onto MyCar install as well and everything works great.

Here is the instructions: http://www.crimestopper.com/cstech/library/security/security_systems/remote_start/mycar_installation_guide_20171109.pdf

Crimestopper TELE-connect not working

Fri, 24 Nov 2017 15:52:45 +0000

Hi there, I'm trying to install the Tele-connect to an evo-one using the T-harness on a 2006 Infiniti G35x with intelligent-Key. I'm using Guide # 33131 I've enabled the following so far but no luck.

32. mode 3

2. mode 3

8. mode 2

RF Kit Compatible has been set to "Fortin 2"

EVO- ONE and Crimestopper TELE-Connect

Mon, 10 Apr 2017 21:16:41 +0000

Hi,

i just installed teh evo one with t harness on 2012 honda civic oem key. i followed everything to the tee and got the evo one to work properly as well as the remote start. I added the TELE-connect Crimestopper and when i go to learn the telematics module to the evo one or vice versa, the installation guide is asking to place the key in the ON position to show the Yellow Led on EVO one. which it does. the next step is to hold the button down for 5 seconds till the red led on the evo one turns on. this part does not happen on the evo one while the key in ignition is in the ON position. i cant get pas that part of the learning process so i cant proceed. i did flash the evo one for configurations to fortin 2 as written on the tele-connect installation guide. i did it under Bypass toggle and remote start toggle. the firmware for remote start is updated to lates firmware and the bypass mode is at 73. 24 as directed by the instructions. ive tried trouble shooting but no luck. hopefully someone can help.