Questions & Answers - Recent questions tagged tip-key-start

2014 ram 3500 will not remote start. Manual transmission

Sun, 13 Nov 2022 01:31:21 +0000

I followed the instructions for the thar-chr7

what else am I missing?

flash link does not have an option for manual transmission

I did not cut the yellow wire

Does EVO-ONE need a clutch wire for 2014 Ram 3500 diesel manual transmission?

Sun, 20 Dec 2020 04:59:32 +0000

After researching my options for a manual transmission I've determined the EVO-ONE coupled with the THAR-CHR6 was the best configuration for a stand alone system retaining original smart tip key. (Please correct if there is another option) According to another Q&A discussion regarding a RAM 3500 manual diesel, it was mentioned by Antoine Marion that a "clutch switch wire" has to be connected. After referring to Guide # 98581 for the EVO-ONE I did not find any information regarding the clutch switch. Shouldn't this be handled through CAN bus or does it need the clutch wire bonded with an output on the EVO-ONE?

2016 RAM 3500 CANBUS Problem

Sun, 23 Dec 2018 01:20:44 +0000

Today I tried installing the Evo-All to a 2016 Ram 3500 diesel using the T-harness. I made it to step 7 and could not get past that.

In step 7 it says “No key = Red” and “Key in= Red and blue”. Whenever i put the key in, the red and blue will stay on for a few seconds then only the blue will stay on. Is this supposed to happen?

I then put it into the RUN position but it will not flash rapidly. If I put it back into OFF, the blue will go back to solid.I checked the CANBUS wires multiple times and made sure they were at the right spot. I even switched them. In step 8 it says “ignition off= red” and “ignition on= red and blue off”. I dont see a red light after step 7 but the blue does turn off when the ignition is on. One thing I did notice though was that the CAN-HIGH wire Grey/White Pin6 on the guide is a different color on my truck; its sort of a tan color but it is still pin 6. The yellow wire DOES match up. Would this have to do with anything?

I followed the intructions on how to test the CANBUS connection and ignition(https://fortin.ca/en/qa/403/programming-evo-all). The ignition is good but whenever I put it in RUN, the blue light will not flash so im sure its a CANBUS problem i just cannot figure out what it is. I also tried resetting the module and it did not work. I updated it to the latest firmware and even dropped it down to the one it says on the guide but that did not work either. I also tried waiting in between the steps and no luck. Any help is appreciated.

Will the EVO-CHRT6 or EVO-One be compatible with a 2014 MANUAL transmission diesel Ram 3500?

Tue, 16 Oct 2018 23:35:25 +0000

If yes where can I find the setup instructions, what additional devices are needed.

I check the guides for the guides for EVO-CHRT6 or EVO-One. But there was no instructions for the manual setup. Also how can I enable smart phone control on the EVO-CHRT6 or EVO-One?

Thanks