/en/qa/tag/wiper Powered by Question2Answer /en/qa/97788/remote-start-status-wiper-interrupt-when-gwr-dark-blue-configured-for-rap-pulse-per-function-mode Product: EVO-ONE<br /> Vehicle: 2010 Toyota Tacoma (Standard 40-bit Key)<br /> Configured per Fortin application note<br /> <br /> I am looking for a signal (negative or positive) to indicate that the EVO-ONE has remote started the vehicle and that it is currently running. Ultimately looking to slave features such as wiper inhibit, defrost, etc. I understand that the Dk. Blue A8 &quot;GWR&quot; configured as Function 32 - Mode 1 or Mode 2 would be exactly what I need however I am required to configure GWR as Mode 3 for &quot;Autolight shutdown&quot; per the installation guide for my vehicle. I haven&#039;t looked at the signal with a scope or logic analyzer to confirm but it sounds like it will pulse ground only at the end of the remote start run but otherwise float high impedance.<br /> <br /> I have scoured all documentation I can find but am wondering if there is another pin which may have an undocumented setting or alternative function which could be used for this?<br /> <br /> I suppose in this case, I could force GWR line back to Mode 1 and then program a microcontroller to then mimic the RAP signal needed for Autolight shutdown -- but -- hoping there is a trick I am missing. Other /en/qa/97788/remote-start-status-wiper-interrupt-when-gwr-dark-blue-configured-for-rap-pulse-per-function-mode Thu, 06 Aug 2020 21:49:57 +0000