Evo All the car doesn't start

Question

Hi. I installed Evo-All on the my Volkswagen Passat B7 2.0TDI  2013 year whith standard OEM key.I used the THAR-VW6 wiring harness. Firmware version 75.40. I trained the module on the car. Then the decryptor cenerated a code , all successful.  But the car won't start with the OEM key fob. The relay in the module clicks , the red light comes on , then the orange light comes on , and the car radio turns on. But the engine doesn't start, and the dashboard doesn't turn on. I connect all the connectors according to the THAR-VW6 instructions.  I didn't connect the wire to the brake pedal ( my car doesn't require pressing the brake to start ) I didn't connect the wires for the start / stop button, as I don't have that button. I used the lock/lock/lock combination to start the engine. Where should I connect the separate yellow wire ( yellow ignition) ?

Answer 1

Hello,

What is the S/N number on the back of the evo?

Thank you.

Comments

I checked contact A20 leading to BT-VW , a voltage of less than 1 volt appears on it when trying to start the engine from the OEM key fob .

---

Ignition gets powered through A11 on the 20 pin connector. Make sure this connector was plugged in.

---

Yes , A11 is connected. I checked A11 when I tried to start the engine, and it showed the same voltage as pin A20 - 0.9 volts. There's no 12 volt signal coming out of the module...

---

What could be the problem?I currently have firmware 75.40 . Rephrase updating to 75.43 will help?

---

Yes you can try 75.43, if that does not work then you will need to phone into the tech line for furhter support.

Mon - Fri

8am - 6pm est

1-877-336-7797

 

Best regards