Questions & Answers - Questions récentes tagguées 2009

2009 rx350 key sense

Wed, 13 Dec 2023 00:38:01 +0000

i have installed EVO-ONE-942 and INT-SL+. The car lock, unlock, remote starts. Everytime i remote start the alarm set off. i follow Guide # 90081. i did hook up the key sense wire. but i didint see any 2 pin white connector shown in the guide. when i remote start the alarm set off so i have unlock and lock and the car stay running. if i cant find the key sense wire. can i change the setting to unlock before start then lock after?

Question with 2009 Honda Accord

Tue, 07 Nov 2023 19:11:24 +0000

Hi

I have a evo one that was used for Honda pilot. The T harness works for my Honda accord which I am using it on. I wired it all up but my car won’t start. I am assuming I have to reflash the evo one for my vehicle for this to work, correct?

Thanks in advance.

Why would my EVO ALL never time out?

Sat, 26 Feb 2022 18:18:18 +0000

I installed a EVO ALL on my 2009 Ford Fusion and it starts fine but i ran it for 25 minutes and it never times out. I also noticed that it doesn't shut off when i hit the brakes either. The only way i can get it to shut off by pressing the lock button 3 times again. SN:001a07333129

Programming issue

Sun, 05 Dec 2021 23:43:59 +0000

I have 2009 Nissan Versa So after connecting all the wires I reached the programming part when I hold the programming bottom to connect the main harness it start changing the led color rapidly and even if I release the bottom it keep changing the led color and never stop until I disconnect the main harness is it something has to do with flushing the module or the wiring

09 focus remote start works great! However the heater fan does not run untill the key is turned on.

Sat, 06 Mar 2021 09:35:02 +0000

Heater fan motor

09 altima evo-all w/thar-nis1 tharness. Wanted to add siren and shock sensor need wiring diag.

Sun, 21 Feb 2021 20:54:05 +0000

Evo,all w/thar-nis1 t harness, oem remote, standalone. Green wires are for lock n unlock. Where is siren wire ?

2009 S4 MANUAL TRANS, NO START AFTER 3X LOCK

Thu, 05 Mar 2020 07:45:30 +0000

Hello,

I have a manual trans Audi s4 2009 keyport Evo One , i have installed the T-harness - yellow line from 6 pin to the clutch bypass (red/blk) in engine bay as per pics, Canbus High and Low installed correctly and the Pink from the 6 pin to the purple/ yellow to convenient ignition out.

I have the module programmed as per intructions and no error. when connect all the plugs and lock the car then try 3x lock to RS nothing happens. I see the module flash with a blue led at every lock and unlock but no ignition.

Evo One S/N 002B04 013291

Thank you in advance!

Stu.

2009 hyundai elantra manual transmission no clutch wire diagram

Fri, 15 Nov 2019 18:17:30 +0000

Can someone pls help me find a wirinf diagram for 2009 hyundai elantra GL manual transmission. I can only find the automatic transmission wiring diagram. Any help will be appreciated. Thanks in advance

2009 Hyundai Elantra GL manual transmission Wiring diagram please

Wed, 13 Nov 2019 02:44:00 +0000

2009 honda accord radio not working not asking for a code and anti theft light is blinking after installing evo one

Fri, 08 Nov 2019 16:20:56 +0000

So i installed evo one with RF kit to this 2009 honda accord. Its was all successful ang everything. Remote start works flawless. But turns our anti theft light keeps in blinking and radio wont even work and wont even ask for a code. Its like blank. I checked all the fuses and they are all good. Even replaced them with new ones just to be sure. Did this happen to anyone else? Do you guy know a way to fix this? Help will be appreciated much. Thanks in advence.

Heater and fan doesn’t turn on with remote start

Fri, 01 Nov 2019 08:31:58 +0000

2009 f150 eco-all stand alone install works fine to start vehicle. All lights and dash light work. However the heat and fan won't run til key is turned to ON position. Any ideas?

No foot brake confirmation from EVO ONE or RF antenna when programming RF642W step 4

Sat, 26 Oct 2019 14:48:10 +0000

No foot brake confirmation from EVO ONE or RF antenna when performing step 4 programming RF642W on Hyundai Elantra 2009. Tested foot brake output at 0.02 volts and tapped in to positive foot brake per instructions. Im thinking voltage from car is too low and EVO won't register activated foot brake and this is preventing me from completing programming step 4.

Dodge Journey 2009 what firmware version do you recommend

Wed, 10 Apr 2019 11:33:47 +0000

My firmware version 74.25 when you start to quickly open and close the doors. If you install the firmware 74.38 the opening and closing of the door is longer.

2009 Infiniti FX35 starts, shuts off after a minute or less

Sat, 02 Mar 2019 20:39:02 +0000

Crimestopper RS7-G4 with evo-all, firmware 72.37. has worked fine for several years. Had an issue several months ago that was resolved by updating firmware to 72.36 and reprogramming tach (would start and stall)

Now, it’ll start, stay running, and shut down after a minute. Attempt to restart, run for a shorter amount of time, and same on third attempt.

I changed firmware to 72.33, 72.34, 72.35, 72.36, 72.37 all with similar results. 72.32 (as recommended in guide 34361)

Is this a faulty module? Or is there another possible solution

evo-one prius 2009

Thu, 10 Jan 2019 07:42:00 +0000

hi just wondering if there is a guide for a evo-one on a prius 2009 ? Thanks

can i use lock unlock unlock to start my lexus so i dont need another unlock remote

Thu, 03 Jan 2019 16:11:04 +0000

Not worried about someone taking car, car will shut down once door is opened

chevy silverado 2008 evo-one with t-harness for alarm and remote start

Fri, 23 Nov 2018 11:17:38 +0000

hello , i'm about to install the evo-one with t-harness to a silverado 2009 with rf kit , i look in the installation guide downloaded from fotin website the main harness of the evo-one doesnot use , but i want to install a siren under the hood , can i plug the main harness in and turn on the option of the evo-one to use the siren and factory horn together? will the power wire of the t-harness can handle all that?

Lexus Gs350 and Evo One +INT-SL+ no work

Mon, 29 Oct 2018 23:22:41 +0000

Lexus GS350 2009 year North America ,Evo One + INT -SL+ no work

many times check connection -all is ok,program module ok ,problem is no start ,no reaction for teach INT SL to door lock -red light onn module stil light ,no flash rapidly .no reaction ,no start.

+12V diffrent color ,no black ,is white/red

Will Evo-For.T1 work on 2009 F150?

Fri, 28 Sep 2018 10:48:08 +0000

Will the Evo-For.T1 work on a 2009 F150? The Evo All installation guide shows a t-harness available but it doesn't show an installation guide. If this unit will work, which installation guide do I use?

Which Start wire to use on Forester 2009 ?

Thu, 27 Sep 2018 12:35:43 +0000

I recently acquired a 2009 Forester. Using a Fortin Evo-All and a Crime Stopper RS2-G3 remote starter I cannot figure out which Start wire to use.

1) Your installation guide suggest the use of Start wires Ter 1 (White/Black) and 2 (White/Red) while the RS2-G3 connector only has one Start wire (Brown). How should I make the proper connection(s) ?

2) As well, the remote starter has two (2) Constant 12V (+) Input Red wires on its 6 pin power harness. Should both of them be connected to the RS2 (+) 12V white wire of the Forester Ignition harness ?

PS. I see that on the Evo One installation you use a relay on the Start Ter 2 wire.

EVO-ONE remote start on Corolla 2009 auto transmission Ready Mode problem

Sat, 31 Mar 2018 11:38:58 +0000

i'm installing the EVO-ONE on a Toyota Corolla 2009 with Axxess AX-RF1 rf kit , after connect all wires and cut the loop wire for automatic transmission then program the EVO-ONE , when program complete i can do remote start once , and then i try again the parking lights flash 3 time because of Ready Mode is disable , so what i have to do to enable the Ready Mode for automatic transmission?

not programming in vehicle

Thu, 11 Jan 2018 20:58:29 +0000

Hi i doubled checked all of my connections in the vehicle when i get to programming it will not work. When i sequence to program for the EVO ONE to have a flashing blue light to recongize that it has been Sucessfully programmed it does not flash just shuts off and then turns on when the ignition is in the off position. This system is being installed on a 2009 mitsubishi Lancer Fast key

Is int-chr2 data link compatible with python 1601 remote start

Wed, 25 Oct 2017 12:14:17 +0000

Installing in a 2009 Dodge Avenger. Using thar-chr2 cable. Is the data-link cable compatible with a python 1601 remote start unit? The cable fits in the mux port on the 1601 unit. Was not sure if this was the same as a data-link.

key sound when the 6 pin is plug without key in ignitiion

Fri, 25 Aug 2017 06:10:18 +0000

Hi guys, I made all of my connection try to make the config and the decryption when everything was fin i re plug my 6 pin connector and the little bell in the car start for advise the key is in ignition if i continue to plug the oters connector that didn<t stop do you have any idea?

Chevy impala 2009 police package.

Evo-one install

what is the connection mode difference between bypass remote-starter in flash-link ?

Mon, 21 Aug 2017 20:26:25 +0000

what is the connection mode difference between bypass remote-starter in flash-link ?

should I set it to remote-starter connection mode where I want installed into my vechile ?

EVO-ALL on 2009 Ford Focus as remote start

Tue, 31 Jan 2017 19:14:26 +0000

I was given an EVO-ALL and FORT1 harness for a 2009 Ford Focus. After looking into the installation is looks like this cannot be used on my Focus as a remtoe start with the OEM fob. Am I out of luck or is there some other component I need?

how can I reset the evo one and start over I can't remote start my Pathfinder

Mon, 17 Oct 2016 21:10:05 +0000

I purchase a evo one for my 09 Nissan Pathfinder hook it up with the T-hareness but had problem with the locks locking after I stop the start moving again so I purchase the Flash Link up dated everything then hook it back up tryed the remote start not working would like to know if there is something else I can do I recheck my wireing eveything is good on that an

Any updates to 2009 Mazda 5 install?

Sun, 14 Feb 2016 13:05:46 +0000

I have a 2009 Mazda 5 Sport. As far as I can tell there is not a 3x Lock option if I want to use my OEM remote. According to this it appears the EVO-ONE has remote start functionality for my car but the EVO-ALL doesn't?

What would I need to start the car with the EVO-ONE?

And the EVO-ALL could only act as a bypass, correct?

2009 Hyndai Sonata

Tue, 29 Dec 2015 04:26:40 +0000

2009 Hyndai Sonata

No immobalizer (Don't have a Green data wire but have Hyndai alarm system and security LED)

Guide # 23951

My 2009 Sonata does not have a Green immobalizer wire at the driver kick panel white connecter. However do i still need to make connections between D4 tol A20 and D6 to A10 ? (In the Guide it shows D6 tol A20 and D4 to A10 but when we trace the wires the connections are in between D4 white green to A20 and D6 white red to A10 )?.

2009 F-150 Thar-for1 t harness support for evo all

Thu, 17 Dec 2015 18:14:10 +0000

I got an evo all to install on a 2009 Ford F-150. I want to use Guide # 32171 to install the unit. But Fortin Thar-for1 harness only compatible with 2011-2014 F-150. Can I use the harness on my 2009?

What EVO I need to remote start 2009 Audi Q5 Push to Start

Mon, 28 Sep 2015 10:48:04 +0000

Hello,

I have a 2009 Audi Q5 Push to Start (regular key fob, not "smart key").

All I want to do is use the factory remote to remote start the car (three "lock" button presses). I don't need any other functionality.

It looks like the EVO-One and EVO-All are both compatible. But I can't tell the real difference between these two.

For the Audi Q5 2009 PTS, which one do I need? What's the difference between the two?