/en/qa/tag/auto-hold Powered by Question2Answer /en/qa/128941/2023-mazda-cx-5-auto-hold-%26-cruise-control-does-not-work-when-vehicle-started-remotely Hello everyone<br /> <br /> I just installed the Fortin Evo-One in my 2023 Mazda CX-5 and everything works fine except the Auto Hold feature &amp; Cruise Control works but get warning lights. but only when the car is started remotely.<br /> <br /> When started normally, it works just fine.<br /> <br /> how i can solve this? Mazda /en/qa/128941/2023-mazda-cx-5-auto-hold-%26-cruise-control-does-not-work-when-vehicle-started-remotely Wed, 21 Aug 2024 06:04:13 +0000 /en/qa/99219/2020-mazda-cx-5-auto-hold-does-not-work-when-vehicle-started-remotely <p> Hey everyone,</p> <p> &nbsp;</p> <p> I just installed the Fortin Evo-One in my 2020 Mazda CX-5 and everything works fine&nbsp;<em>except</em> the Auto Hold feature, but only when the car is started remotely. I've made sure all doors are closed, my seatbelt fastened, car fully stopped in drive and I just get 3 flashes.</p> <p> &nbsp;</p> <p> When started normally, it works just fine.</p> <p> &nbsp;</p> <p> I've tried re-flashing the Evo-One module and tried running the DCryptor sequence again but same issue both times. Unit was installed with the THAR-ONE-MAZ3 T-Harness.</p> <p> &nbsp;</p> <p> Has anyone else had this issue or have any troubleshooting advice?</p> Mazda /en/qa/99219/2020-mazda-cx-5-auto-hold-does-not-work-when-vehicle-started-remotely Thu, 29 Oct 2020 21:02:50 +0000