Questions & Answers - Questions récentes tagguées canbus

EVO ALL CAN Bus confusion

Sat, 19 Oct 2019 20:41:52 +0000

Good evening,

I am wiring up an EVO All with a Viper 4706V on a 2015 KIA Sorento. I am confused on the CAN1 and CAN 2 locations. According to guide 10841, CAN1 is located on the back of the fuse box, and CAN2 is located on the ODB-II connector. Yet, WIRECOLOR.com shows the opposite. And looking at the standard pinouts for ODB-II, it just shows can bus high and low on the ODB-II, no 1 or 2 spec.

Anybody out there do one of these installs? Not sure which doc to trust here...

Thanks,

Jim

Santa fe sport CAN BUS problem

Sat, 13 Oct 2018 22:19:43 +0000

My vehicle programming evo unit without error, 3x oem remote start well but while engine running i can not unlock door from remote. After check CAN BUS connection with meter, voltage at CAN 1 HIGH ~5V, CAN1 LOW ~0V. CAN2 H & L ~2.5 V I don's think this is error system because all function working good. My model is ASIA santa fe sport

2018 Toyota Tundra will not program Can Bus, what are next steps?

Tue, 13 Feb 2018 14:04:42 +0000

I have system fully installed. When going through programming, can bus programming yields a red light. Voltage on Can Bus Low is 2.42vdc Can Bus High is 2.62vdc on Fortin can bus wiring harness. I tried alternate can bus programming (let go of program button on blue light, turned ignition on, get blue flashing lights). I have tried reprogramming 10+ times, immobiliizer programming is successful. Using THarness. Open ticket is 10820

Bypass Firmware 79.45

Remote Start 1.24

C1, D2, 2-4, 38-2