Questions & Answers - Questions récentes tagguées crimestopper-lc-1

Why are datalink protocols F1 F2 F3 off?

Mon, 29 Oct 2018 16:19:49 +0000

I have been having issues with my remote starter system. My setup is a regular type with an Evoall and a crimestopper LC1 unit. Remote start doesn’t work after car battery replacement. 3x lock doesn’t do anything.

I tried to start the car with the remote that came with the LC1 unit and it does work! The OEM remote (3x press) does nothing but blue led flashes everytime i press it.

Im looking at the enabled features on my evoall unit and noticed that all data protocols (F1, F2 and F3) are off. Im curious if this is normal?

What else could i check on my setup?

Thanks

Issues after battery replacement

Sat, 13 Oct 2018 12:10:27 +0000

Hello

im having issues when remote start after a battery replacement on my car. Everything used to work very well. Wiring is intact.

My setup is a regular type with an Evo all and a crimestopper LC1 unit. Remote start doesn’t work at all after the battery replacement. 3x lock doesn’t do anything.

Blue led does flash on evo all when I lock - I lock car.

Can you please give me some ideas on what to check?

Thanks

External door keypad will trigger remote start

Sun, 16 Apr 2017 12:57:29 +0000

Hello

i have a 2015 focus se with a EVOAll and crimestopper lc1

my car has an external keypad on the drivers door. This allows to lock/unlock and open the trunk. Pressing keys 7-8/9-0 simultaneously and 3 times will engage the remote start! Is there any way to disable that?

I don't like the car being exposed at any remote start just by pressing those 2 buttons. Anyone could do it!

thanks

EvoAll standard to standalone

Fri, 14 Apr 2017 21:43:29 +0000

Hello

I have a EvoAll with a crimestopper LC1 remote module. I haven't installed it yet but I assume this system runs as a standard system and not standalone.

my car is a 2015 Focus se sedan

I was wondering if is possible to disconnect the lc1 from the evo all and configure it to run as a standalone only unit? If so, what settings need to be changed on evoall?

also, I see the following cables on the lc1 unit. Can I just disconnect them?

ignition - out - goes to evoall key sense a1 and rs7 on thar-for1 (yellow/black)
12v - in
Gnd when running - out - goes to a8 on evoall

thanks