Questions & Answers - Questions récentes tagguées dodge-durango

2004 dodge durango evo-one thar-chr5 Blue light doesn't stop flashing

Tue, 04 Feb 2020 19:04:59 +0000

During programming when I plug in the white E 6 pin connector blue light goes out. When I turn the key on the blue light starts flashing. Doesn't stop flashing at step 6. After starting the vehicle with key it, the yellow light comes on and stays on. When i try 3x lock, the blue light flashes once per lock, but does not try to start.

2004 Dodge durango evo one programming. blue light wont stay on on mode selection

Sat, 21 Dec 2019 19:38:56 +0000

So i hard wired everything. In the programming procedure. Blue light wont stay on. I checked everything is all in order. Does anyone know what is happening? Thanks

2014 durango evo all. T harness stand alone is programmed but wont start.

Sun, 08 Dec 2019 23:42:01 +0000

Connected ignition wire to the red green wire in driver side kicker panel as shown in install video. All lights on evo all work when hitting lock 3xs.

2016 Durango Key Fob Not Detected intermittently

Fri, 16 Nov 2018 11:46:53 +0000

Installed my Evo-CHRT6 kit (t-harness and stand alone) last night on my 2016 Dodge Durango (PTS) , intermitantly when i try to remote start the dash will say "Key Fob Not Detected". The evo has been flashed to the newest firmware, i have reprogrammed 5 times and decrypted 5 times, and continue to have the same issue. It seems to work 1 out of 7 times when remote started, when it does not work it causes the ignition button to not work for the run interval time (i have set it to 20minutes). Any thoughts or ideads about what might be causing this?

Thanks

follow up to response

Mon, 28 Apr 2014 14:31:10 +0000

Thanks so much for your reply.

Service # is 001A06 145015

I grounded the dark blue wire temporarily, I'm awaiting for a tilt swithch for the hood to be sent to me which I ordered online.

Was grounding that wire my mistake?

Red Light result after programming

Sat, 26 Apr 2014 18:06:07 +0000

2012 Dodge Durango CHRT4 Connection C (stand alone). Have everything wired up but keep getting Red Light as result on the last step #8 (Press the lock button on OEM). Everything else up to that step. Ignition Yellow wire from 20 pin is matched up to Yello wire from T Harness. Not using Extenral Input or Parking light out as indicated.

Thanks for your help!

Question about remote start mod on 2008 Dodge Durango

Sat, 25 Jan 2014 19:29:58 +0000

I have had the remote start mod installed for a little over a week and it has worked flawlessly.

But today I set out on a road trip and all of the sudden all my dash warning lights came on and the speedometer

and tach dropped to 0. It would go out and come back on constantly. I removed the mod. and all the lights are still

on. Any chance the modual could have fried something in my computer? I have the EVO-CHRT5 on my 2008

Dodge Durango.