Questions & Answers - Questions récentes tagguées drivers

Unable too install drivers

Tue, 17 Dec 2019 12:18:10 +0000

Hey trying to install the drivers for my FLLon my 2017 Honda Fit, I have updated windows tried the fortin manual driver install I was unable too locate the Flash link drivers, I recieved a new FLL from MYpushcart It cannot find the drivers anywhere?

USDM 2013xB Canbus Door lock control?

Fri, 30 Dec 2016 00:22:23 +0000

I recently got my evo one today, and installed it after some back and forth with the firmware and the updates. It starts using the lock-unlock-lock feature (did this so that the alarm is in a disarmed state when the engine starts, so no need to splice into key sense) However, when I start the car using the remote, nothing happens when i go to try and unlock the doors using the remote. I know that the car ignores the remote with the engine started, and I can see that the evo one is recieving the lock and unlock commands from the vehicle(can see blue light blinking with each key press ) but I'm unsure if the doors are supposed to unlock with from the can hi and can lo connections, or do i have to splice into the door lock and unlock wires in order for the door to unlock?

EVO-ALL driver's door won't lock

Sat, 10 Dec 2016 12:17:47 +0000

HI, please help. I have exact same problem as described here:

https://fortin.ca/en/qa/21843/driver-door-will-not-lock-after-remote-start

except that I installed the remote start (Compustar CM7200 remote starter + DR3100 cellular Drone module + Fortin EVO-ALL immobilizer bypass) on my daughter's 2009 Subaru Impreza sedan. (I'm not a pro installer, just a DiY'er)

The driver's door won't lock. It won't lock when commanded from the Compustar keyfob, it won't re-lock after remote start (I enabled the unlock-start-relock because otherwise the alarm would go off every time when remote started). it won't lock when commanded from the Drone app.

Every time the doors are supposed to lock, all doors lock fine, except the driver's. I hear the driver's door lock locking, and then immediately unlocking.

So, what should I do? Cut wire A10 (it seemed to help the guy with the Kia)? Or wire A20? Or do something else? It has to be fixed, I can't let her leave the car with engine running and unlocked driver's door, especially when the car is out of sight (which was the whole point of going for the Drone)

Please advise. Thank you!

(P.S.) everything else works just fine