Questions & Answers - Questions récentes tagguées evo-all-flashing-led

After step 13 of programing, all three lights are flashing not just yellow and red.

Mon, 05 Dec 2016 11:06:53 +0000

While programing the Evo All, stand alone starter, with mazda t-harness, I'm not getting the yellow and red flashing lights after step 13. Instead all three lights flash at the same time. If I hook it up to the flash link to use the Dcryptor, it's says there is incomplete key information. I don't know what to do from here. Any suggestions. I did try a factory refresh but am getting the same thing. Everything seams to go right up to step 13.

during programming at the end all three led lights are flashing

Thu, 04 Aug 2016 22:03:27 +0000

2004 infiniti i30 cheched all wiring good. solders have good connections. soild clean groung. use connection one and program 1 good power source and ground. will not take program. at the last step all the light flash together. dont know why?

Programming procedure 1- get solid yellow for 10 seconds then all 3 start flashing

Mon, 14 Dec 2015 15:13:38 +0000

I can't get past step 1. I let go of button on evo-all once I have the yellow led. About 10 seconds later all three led's flash simultaneously.

Tried resetting the unit several times and still doen't work.

Cannot move on from this step.

Thank you for your assistance.