Questions & Answers - Questions récentes tagguées hybrid

2016 camry Hybrid

Wed, 05 Feb 2025 11:46:52 +0000

Hello. On 2016 Camry 2 pcs Evo-All I wanted to be programmed and on both after turning on the ignition after 10 seconds the red LED starts blinking. 001A07579416

2014 VW Jetta Hybrid - Does not always start, sets CEL and EPC light on dash

Sun, 15 Oct 2023 14:18:40 +0000

Greetings all,

2014 VW Jetta Hybrid Push to start, buried key, used THAR - VW1 w/EVO-ALL. Checked connections 4 times over, no issues with wiring, I can affirm this vehemently. Vehicle attempts to start, fails randomly. EPC and CEL lights will illuminate on dashboard, DTC P0703 will set for a circuit malfunction. Correct pin and wire color are tapped, as I have checked this vehemently. If you push your foot on the brake and remote start, the DTC will still set. If you start the vehicle normally, the DTC will NOT set, even with everything connected the same.

The vehicle will also NOT retry starting once the ignition is on, I'm not sure why this is. It will just sit there for 15 minutes with the ignition on, but no engine on.

When this concern initially appeared, I rolled the firmware back a version and this fixed the issue temporarily. I let the vehicle rest overnight and the issue returned next day.
Does anyone have any info on this? Please let me know, thank you.

Low battery causing horn to go off on 2017 RAV4 hybrid?

Mon, 02 Oct 2023 16:19:28 +0000

Our 2017 RAV4 hybrid was parked for a few weeks causing the battery to run down as it has a tracker installed. All of a sudden one morning the horn faintly started to go off intermittently. There was no one around it. Is it possible that it was the Evo that’s installed in it was causing it to go off? Thinking that someone was messing with the battery? If so is it possible to disable this as it keeps going until the battery is basically completely dead. We have since charged the battery and are driving it every few days and there has been no issue since. Thanks

Hood pin wire 2017 Toyota RAV4 Hybrid

Mon, 23 Jan 2023 11:49:24 +0000

Where would I need to tap the pink/black wire from the Evo one for the hood pin switch on the interior? I believe it's on the body control module but I'm not sure which connector or wire. I would rather use the factory hood switch if possible rather than installing the aftermarket one and not have to run a wire through the firewall. Thanks

2021 Corolla Hybrid remote start in AUX mode Not ready

Sun, 09 Jan 2022 14:32:17 +0000

have a 2021 Hybrid Toyota Corolla remote start works up to the point it puts it in AUX mode so the motor never starts to warm the car up kind of defeting the point of remote starting have reprogramed a few times but cant get it to start the car.

2020 corolla hybrid start wire & override switch

Sat, 28 Aug 2021 10:54:24 +0000

Today I installed the EVO ALL in my 2020 Toyota Corolla GR Sport Hybrid, unfortunately the hybrid start wire was too short because I wanted to mount the module all the way on the left behind the cover for easy access. However upon testing all still seemed to work (blower goes on, which for me is the most important, both in winter and in summer). My question is what exactly does this wire? I can simply extend the wire, but I feel a bit hesitant cutting and soldering the original wire (it is very thin, so I don't want to use a splice connector).

I guess this is for the car to be able to start if the battery becomes low because of the blower (and lights and radio) going on?

Also was wondering what the override switch does, suppose only as an emergency for when the EVO for some reason fails?

There are a lot of spare wires, from the big white connector they seem spare I/O, but from the smaller white connector there are 2 orange wires which don't appear in the instructions. Wish the instructions explained all the connections a bit more.

Guide 93711 2019 Toyota Rav4 Hybrid--is option D4 required (hybrid mode)?

Tue, 27 Apr 2021 21:07:17 +0000

Install guide doesn't mention enabling option D4 for Hybrid mode, although the guide is specific for Hybrid. Is this an oversight, or is it not required for this vehicle?

Remote Starter will not start Prius C

Tue, 22 Sep 2020 16:06:29 +0000

When pressing the Start button on the remote, the lights on the vehicle flash four times and doesn't start.

2020 toyota rav4 PTS hybrid?

Thu, 07 Nov 2019 12:15:15 +0000

any support coming for 2020 Toyota Rav4 PTS hyrbrid soon?

Do you need extra wiring for a 2017 rav4 hybrid

Wed, 25 Sep 2019 22:03:22 +0000

Is there extra wiring required for push to start hybrid2017 Rav4? If yes, is it included with theT- harness. thank you

2010 GMC Sierra Hybrid won’t remote start

Sat, 21 Sep 2019 22:21:08 +0000

Installed remote start using all instructions. Downloaded the fortin flash link system to update and program and the truck still does not start. It seems like the hybrid system turns on but nothing else. It also sometimes locks al doors and unlocks. Then it is giving an error message to service the security system (used a different word but same idea) and alarm goes off.

2013 Prius C

Wed, 29 May 2019 10:06:52 +0000

Installed a remote start on a 2013 Prius vehicle starts and stops as it should from the key and the remote start but customer is saying there is now a hybrid error showing on the dash. There arent any check engine lights on just saying the hybrid system needs service. I called tech support and they suggested going to the dealer for service but the customer took it to a local service station who said the remote start is causing the problem. Has anyone else had this issue? i don't believe its from the remote start as I said it functions normally

2010 Ford Escape Hybrid Door Pin Wire Location

Tue, 05 Mar 2019 18:06:00 +0000

I FINALLY found the 26 pin plug where the Green/Violet Driver Door Pin wire is located. It's in the driver kick panel. But it is all but impossible to get to. Really really really difficult as it is buried behind steel braces that cannot be removed. There is certainly not enough slack to get fingers in there to cut the wire and then attach the 2 separate wires needed. How do I accomplish this?

2012 Ford Fusion Hybrid Compatibility

Fri, 14 Dec 2018 13:07:53 +0000

I've purchased an Evo about a year ago, installed everything and could never get it to work. It would set off the alarm instead of starting. Unfortunately, I had to return it. I would like to try again but I cannot get a clear answer. Is the system even compatible with a 2012 Ford Fusion Hybrid? There is no mention of the Hybrid on the site, just the standard. I would like to get a clear answer and purchase it again if I find out it should for sure work.

Do I need to connect the main connector?

Tue, 27 Mar 2018 10:25:33 +0000

I have an EVO-ONE with TOY6 harness for a 2018 Highlander Hybrid PTS. I'm using the install guide #70741, which support said was the correct one. In this guide it says to tape over the main connector to prevent shorting to ground, but further down the guide it says to plug in the main connector to program key pass. Do I need to connect the main connector to pwr/gnd or does the evo-one get power from the t-harness? Which connector do I need to plug in to complete the key pass programming? Thanks.

Can we do remote start on a hyundai 2018 ioniq plug in hybrid?

Sat, 17 Feb 2018 08:15:18 +0000

I no we can do a normal hybrid.but can we also do a plug in hybrid? Tha ks

Can EVO-ALL standalone be installed into a 2007 ford escape hybrid?

Mon, 01 Jan 2018 12:09:09 +0000

Guide 32171 (THAR-FOR1 THARNESS stand alone installation) indicates that the evo-all module can be installed into a ford escape hybrid vehicle.

The evo-all module I have is programmed with C1, D1, D1.6, A5 off, program lock, and H2.

It is not programmed with D4 though. Guide 34441 for stand alone installation shows that the D4 option is required for hybrid vehicle, which mine is).

I have a T harness also with this module.

Does the evo all module have to be programmed with option D4?

Also, the lock/unlock input external controls are connected via a dashed line in guide 32171. Do these dashed lines indicate that they don't have to be connected as it is an option?

Thanks for your help.

Can the Evo-all be installed as a stand alone with take over for 2007 Toyota Camery hybrid PTS?

Fri, 09 Dec 2016 14:43:41 +0000

I am not able to find the guide for installing the Evo-all as a stand alone with take over for 2007 Toyota Camery hybrid PTS. They only have a guide for the Evo- one system. Can someone direct me to the correct guide? My install would include the crimestopper revo-4 and would like the take over so I don't have to start my car twice.

Lock and Unlock for Toyota Camry PTS Hybrid 2016?

Tue, 23 Feb 2016 19:42:36 +0000

Can someone help me identify where the lock and unlock on the Toyota Camry Hybrid PTS is? The wirecolor guide doesn't have it listed at all.

Is it in the same location as the H-Key 2016 camry? (RED & GREY, 18-pin connector in driver kick panel)?

Thanks in advance!

installer says that Key-override-all is defective

Sun, 17 Jan 2016 17:20:06 +0000

I had a rs-160-edp+ v-2.0 installed by a local insaller and he is telling me that the key-overide-all is causing my 2009 ford escape hybrid to resart and that it is defective and I need to replace it . The vehicle wil lsart but it stops runing after about ten seconds and then restarts.

tach wire for ford escape hybrid 2009 with ms sync

Sun, 17 Jan 2016 16:56:29 +0000

the wiring diagam shows pin 140 (ac/data)but on the ford escape hybrid 2009 with MS sync that wire is not there. what wire is the right wire for the tach?

What are the proper EVO settings for a 2012 Camry PTS Hybrid?

Thu, 17 Dec 2015 14:32:33 +0000

Flashing and EVOALL as a standalone for a 2012 Camry PTS Hybrid.

C1, D1, D1.6

D4, D6....

How about D5? Anything else?

Well is it normal for the evo not to turn on the ready to drive light on a fusion hybrid??

Sat, 03 Jan 2015 15:13:49 +0000

The dash lights up basically like with key in the ignition but the check engine light comes on and stays during the entire remote start sequence!! Never seems to go into full on?? During and I've already ran it through at least complete remote start cycles and still won't start engine!! Otherwise seems to be working fine!! The temperature here is around 40 degrees Fahrenheit today!! Again the ready to drive light doesn't come on at all during remote start!! This after 4 or 5 complete remote cycles!!