Questions & Answers - Questions récentes tagguées in

2014 Chevrolet tahoe, after remote starting, engine stops running immediately when key inserted or brake pedal presed

Thu, 19 Dec 2019 15:24:23 +0000

Installed evo-all on 2014 Chevrolet Tahoe with t-harness and without data link. Firmware version 70.24. After remote starting vehicle then unlocking doors, entering the vehicle and closing doors the engine immediately stops running after brake pedal is pressed or key is inserted into ignition.

How can I get the lights back to working in the rear hatch on a 2008 GMC Acadia

Thu, 28 Dec 2017 10:31:10 +0000

What color is the power supply and ground coming into the rear hatch and loaction of a 2008 GMC Acadia and is there a fuse somewhere going to this power supply? I was trying to see if I could get the tag type back up camera to work on this vehicle and there was a red wire coming out of the camera wire not hooked to nothing that got aganist the groung and that is when it went dead along with the lights in the hatch. The other part of the red wire still has power when you put vehicle in reverse. but the red wire hanging loose and the lights in the rear hatch has no power at all, I have checked every fuse in the car and especially the camera fuse and they are all good even tho it seems like I blew a fuse when the loose red wire sparked aganist the ground while I was moving wire around. At this point if I could get the lights back to working correctly in the rear hatch I could do without the camera. Pleas help

Eddie Cansler

Could I plug my Flashlink 2 unit directly to my EVO-ONE while it's still wired up in my car?

Thu, 10 Nov 2016 21:47:03 +0000

Just for future reference... Could I leave my EVO-ONE in my car with all the wires connected and hook up my Flashlink 2 module to update? Or do I need to remove the EVO-ONE and then connect to Flashlink?

Any replies much appreciated!

Installed evo one found out car doesn't have a chip.

Sat, 24 Oct 2015 19:28:31 +0000

Have a 2012 Toyota Sienna. I installed a evo one and have a crimestopper revo4 rf kit. After installation I found out the car doesn't have an immobilizer. How can I program the module to start the car regardless?? This car doesn't have the G key or push to start.