Are my setting correct for 2018 f150 standalone installation

Tue, 21 Aug 2018 02:59:19 +0000

Are my settings correct for standalone installation 3xlock using thar for3 t harness? Regular key, i turned on push to start option will key start work with that option turned on? Is hood switch jumper mandatory?

blank after keys programmed and car doesn't start after correct installation

Wed, 17 Jan 2018 22:19:46 +0000

Mazda CX-5 2016 auto w/ push to start
Parts Used: Evo-ALL with THAR-Maz1 hardness
Guide Used: 62951
Wires hooked up:
Parking Lights- Yellow/Red, Yellow/Blue, Yellow/Green
Connector A into Connector C and Connector B plugged into Plug 1.
Data Door Lock- Lt. Blue to Green/Orange
Data Key- Lt Blue/Black to Black/White
Yellow- Nothing NO RF KIT USED
White and Black plugs on end of 4-wire Data plug- nothing (NO RF KIT USED)
(-) Lock, (-)Unlock, Start/Stop External- None hooked up, USING OEM KEYS TO START.No Hood Pin installed, Hood Pin Wire connected to Black Wire (PA-pin7-PB-pin11) in Fusebox

After completing step 12 on guide the yellow light turns off and nothing happens. The unit just goes blank. First thing I did was try to find a solution. Then I reflashed the unit with the firmware and tried it all over again. Nothing changed still all same results so I went over all the connections I made and all are firm and good connections. I don't don't get any flashing lights to indicate a fault either.

I have solved all issue, please read my replies. if I can help post or email me at matthew.irizarry.mi@gmail.com I will try to assist you if you have the same car and unit as I do.

Questions & Answers - Questions récentes tagguées jumper

Are my setting correct for 2018 f150 standalone installation

blank after keys programmed and car doesn't start after correct installation