Questions & Answers - Questions récentes tagguées nissan-armada

do nothing when lock 3x with oem remote

Fri, 22 Feb 2019 18:44:39 +0000

I can not get anthing with oem remotes 3x lock (no start) no lights.

programing evo-one unit done alternate red and yellow

Bypass 72.[37]

Remote start 1.[24] hardware 7.0

i have setting: 2-3

20-2

32-3

EVO ALL ONE programming issues

Mon, 17 Sep 2018 18:55:09 +0000

During programming of the EVO ALL in ONE the yellow light flashes and when I install the key to get the red and yellow solid light the blue light also comes on immediately solid and never goes out. So all leds stay lit solid at this point and I can go any further.

Nissan Armada Evo- one remote starter on step 5 red light won't come ON

Sat, 12 Dec 2015 18:07:11 +0000

On step 5 I have followed by inserting the key in and turn on but the light still yellow solid and doesn't show red light, What I should do and did I do something wrong, pls help

thank you for help and Ido appreciate,

chris

Nissan armada Red light on step 5 didn't turn on

Fri, 11 Dec 2015 20:11:45 +0000

I followed all the steps, on step 5 red light should but it didn't on, I did repeated few times still not on, What might be the problem? Pls help,

instruction says, the battery must out from remote and must 3 meters away from vehicle,

What will happen if the bat still in the remote and only 2 meters away? Pls help

can I connect parking light wire, ? If not why, and how to make it wort?

thank you so much, I need help,

EVO-ONE will not remote start on 2015 Nissan Armada

Wed, 26 Aug 2015 17:49:22 +0000

Using EVO-ONE bypass firmware version 72.19, t harness and RF642W 2-way remotes on 2015 Nissan Armada with Intelligent Key.

Remotes will lock/unlock and communicate with vehicle, but will not remote start vehicle. Noted during key programming that module does not operate park lights, so no park light flash code to use. Module programming, key programming, and remote programming completed, but vehicle will not start with remotes. Will make two attempts to start (can tell by driver's foot light operating), but dash lights do not come on and vehicle does not start. Occasionally, vehicle alarm will sound after first attempt (of two) to start. Module programming LED will flash after failure to remote start. Does not appear to be a flash code. While attempting to start, various module LEDs will flash on and off briefly. 2 way communication works properly (remote beeps to indicate remote start failure), and lock/unlock function of remote work normally. Query of vehicle status works normally. All wiring double checked using guide #17763. Ignition diode indicated in EVO-ONE box (rev. 20150225) installed.

2012 Nissan Armada Smartkey won't stay running

Mon, 29 Dec 2014 11:41:42 +0000

Recently installed a remote start for a customer in a 2012 Nissan Armada. Unfortunately the vehicle is 200 miles away and won't be able to be in the shop until this Sunday (when tech support is closed).

I don't have the service number on the EVO-ALL but am 100000% positive that I am using the right firmware and that all connections are proper.

When the vehicle left the shop it was working 100% perfectly, however after a day of use the customer noticed that the vehicle would start for only 3 seconds before shutting off. It was long enough that the remote starter saw the tach signal and assumed the vehicle was still running as it was still counting down the timer on the fob, so I'm ruling out starter issue (for now). Does anyone have any other ideas/thoughts on what could be causing this? Would a GWR wire cause this? Is it possible it lost it's transponder programming?