Dodge RAM SRT-10 Standalone install not working

Wed, 14 May 2014 20:37:31 +0000

Hooked up a EVO-CHRT5 kit to a 2006 Dodge RAM SRT-10 as standalone, ran into two issues.

First, following the install guide I used connection 'F'. However there wasn't a green/yellow starter wire so I moved to connection 'C' as the guide instructed. On further inspection, the plug inside the SRT-10 with the 12v, IGN, and MUX wires is different than the one pictured in the guide, as well it has 6 pins instead of 5. Is there a different guide for the SRT-10 or is it not compatible?

Second, after following connection 'C', the EVO-ALL programmed normally. Option 15 was set to Standalone Mode before installation with the Flashlink Updater. However, when I hit LOCK 3x the car does not start. The RED LED on the EVO-ALL comes on, followed by the YELLOW, then the BLUE flashes extremely fast. The truck does nothing during this, no ignition, nothing.

I have tried Firmware 4.09, 4.18, and the recommended one as well. Same results for all of them. Any help would be greatly appreciated!

Questions & Answers - Questions récentes tagguées ram-srt10

Dodge RAM SRT-10 Standalone install not working