Questions & Answers - Questions récentes tagguées s5

evo-all on 2009 audi s5 will not learn/decrypt key with T-harness

Sat, 14 May 2022 18:48:29 +0000

I have tapped all he correct color wires by the punch and twist method, The T-harness is fully seated into the keyport module. Per the guide I am using the recommended 60.10 firmware. when Igo through the process on learning/decrypting the key, the evo all only gets to the point where all there leds alternate. but instead of getting a solid red led and then the slowly alternating red and yellow. I only get the red led that blinks 3x. and it never changes. I have also tried the alternate firmwares [.08] through [.11] and have had the same results. I have put a brand new batttery in the vehicle and the remote as well. I tried programing the evo with the option A11 both on and off.

What else can I try? serial# : 001A07321568

Best wishes,

Evo-All vs Evo-One for Audi S5 2018?

Sun, 15 Nov 2020 13:08:24 +0000

I'm looking to buy a remote starter but don't see the difference between the 2 models suggested for my car. What are the differences?

What's the max distance to remote-start the car?

My car is still under warranty. Can I still install the remote?

Thanks

2009 Audi s5 manual evo-one with thar-audi blue led stays solid will not program

Mon, 03 Jun 2019 14:09:54 +0000

2009 Audi s5 manual transmission, keyport and start/stop button with evo-one with thar-audi t harness. The blue led stays solid when the ignition is turned on with the keyport and I am unable to program. I have checked the yellow starter wire connection to the clutch bybass and the connection seems solid. The 12v to the juction box is getting a reading and good. The can high and low are also connected good. The connection for the vehicle is clipped together and the plug for the evo-one is connected as well. The 16pin is also plugged into the keyport.

When I plug the data cable in while holding the program button the led turns blue. I plug in all the other cables, insert the key, and press once WITHOUT pressing the brake. When I press and release the the program button the blue led remains on as if nothing has happened.

Any help please?

what wires are needed to install in a 2013 audi s5 with pts. stand alone install..? installing the EVO-AUDT1

Sun, 10 Feb 2019 01:48:15 +0000

2013 audi s5 push to start, wires needed for stand alone install.