<?xml version="1.0" encoding="utf-8"?>
<rss version="2.0">
<channel>
<title>Questions &amp; Answers - Questions récentes tagguées shuts</title>
<link>/en/qa/tag/shuts</link>
<description>Powered by Question2Answer</description>
<item>
<title>2020 Toyota 86 (PTS) starts for 2 seconds then turns off</title>
<link>/en/qa/111581/2020-toyota-86-pts-starts-for-2-seconds-then-turns-off</link>
<description>I have an automatic 2020 Toyota 86 (PTS) with an EVO-ONE installed. From my knowledge, we have all the wires tapped properly. We ran into a few issues with the immobilizer wire but I believe we got that part sorted out.&lt;br /&gt;
&lt;br /&gt;
To confirm with the immobilizer wire, we cut the yellow immobilizer wire in half, tapped the light blue black and yellow red to the immobilizer wire that&amp;#039;s connected to the ECU, and tapped the yellow green to the immobilizer wire that&amp;#039;s connected to the other side of the car. Is this correct or should it be flipped? We&amp;#039;re not able to aquire the immobilizer data for DCryptor but I think it&amp;#039;s because it&amp;#039;s not listed as supported on fortin&amp;#039;s website, even though we go through the guide and finish with the Yellow and Red lights alternating on the EVO-ONE before attempting to use DCryptor. (Leaves us with a &amp;#039;No data found&amp;#039; error).&lt;br /&gt;
&lt;br /&gt;
Finally, we installed the antenna for the RFK411 remote and programmed it. When starting the car, it starts for about 2 seconds then turns off. Does anybody know what could be causing this issue?</description>
<category>Toyota</category>
<guid isPermaLink="true">/en/qa/111581/2020-toyota-86-pts-starts-for-2-seconds-then-turns-off</guid>
<pubDate>Sat, 26 Feb 2022 10:12:56 +0000</pubDate>
</item>
<item>
<title>2013 Toyota Venza takeover?</title>
<link>/en/qa/98044/2013-toyota-venza-takeover</link>
<description>I have Evo All hardware version 6 latest firmware, when I open the door the vehicle shuts off, is takeover available?</description>
<category>Toyota</category>
<guid isPermaLink="true">/en/qa/98044/2013-toyota-venza-takeover</guid>
<pubDate>Sat, 29 Aug 2020 10:43:51 +0000</pubDate>
</item>
<item>
<title>My remote start shuts down after a few seconds if it is hot out and the AC is on</title>
<link>/en/qa/97515/my-remote-start-shuts-down-after-a-few-seconds-if-it-is-hot-out-and-the-ac-is-on</link>
<description>2015 Subaru Forester.&lt;br /&gt;
&lt;br /&gt;
My remote start shuts down after a few seconds if it is hot out and the AC is on when the car starts. Is there a way I can prevent the remote start from shutting down? I have no issue in the winter when I leave the heat on to warm the interior however, in the summer heat, if I leave the AC on, then remote start, the car shuts down after a few seconds. Is there a way to prevent this or troubleshoot the exact fault that is occuring?</description>
<category>Subaru</category>
<guid isPermaLink="true">/en/qa/97515/my-remote-start-shuts-down-after-a-few-seconds-if-it-is-hot-out-and-the-ac-is-on</guid>
<pubDate>Wed, 15 Jul 2020 14:25:10 +0000</pubDate>
</item>
<item>
<title>2013 Toyota Tundra starts for a few seconds then shuts off</title>
<link>/en/qa/96722/2013-toyota-tundra-starts-for-a-few-seconds-then-shuts-off</link>
<description>I have tried everything. I am pretty sure it&amp;#039;s programmed correctly. It starts then shuts down seconds later. I am all out of ideas and ready to give up. Service number 002BO7 339682</description>
<category>Toyota</category>
<guid isPermaLink="true">/en/qa/96722/2013-toyota-tundra-starts-for-a-few-seconds-then-shuts-off</guid>
<pubDate>Sat, 11 Apr 2020 21:18:55 +0000</pubDate>
</item>
<item>
<title>car starts then shuts down</title>
<link>/en/qa/94384/car-starts-then-shuts-down</link>
<description>I am installing an Evo one in a 2013 Subaru Outback with automatic transmission. The module was flashed with the correct software and programmed correctly and when I remote start it, it starts then shuts down. It tries a second time and then park lights flash 4 times The SN of my module is 002B04 051414</description>
<category>Subaru</category>
<guid isPermaLink="true">/en/qa/94384/car-starts-then-shuts-down</guid>
<pubDate>Wed, 01 Jan 2020 18:01:05 +0000</pubDate>
</item>
<item>
<title>2009 Infiniti FX35 starts, shuts off after a minute or less</title>
<link>/en/qa/86714/2009-infiniti-fx35-starts-shuts-off-after-a-minute-or-less</link>
<description>Crimestopper RS7-G4 with evo-all, firmware 72.37. has worked fine for several years. Had an issue several months ago that was resolved by updating firmware to 72.36 and reprogramming tach (would start and stall)&lt;br /&gt;
&lt;br /&gt;
Now, it’ll start, stay running, and shut down after a minute. Attempt to restart, run for a shorter amount of time, and same on third attempt.&lt;br /&gt;
&lt;br /&gt;
I changed firmware to 72.33, 72.34, 72.35, 72.36, 72.37 all with similar results. 72.32 (as recommended in guide 34361)&lt;br /&gt;
&lt;br /&gt;
Is this a faulty module? Or is there another possible solution</description>
<category>Infiniti</category>
<guid isPermaLink="true">/en/qa/86714/2009-infiniti-fx35-starts-shuts-off-after-a-minute-or-less</guid>
<pubDate>Sat, 02 Mar 2019 20:39:02 +0000</pubDate>
</item>
</channel>
</rss>