/en/qa/tag/trouble Powered by Question2Answer /en/qa/85794/my-evo-one-doesnt-program SO i bought the kit for the plug and play for remote start for my 2015 rav4 along with the T Harness. everything is installed correctly. I am running on the 79.49 bypass and 1.24 on the remote starter. it doesnt seem like it wants to go into the programming mode. i have held the buttion so the red and blue light stood soild than i plug in all the wires as followed by the instructions. it blinks 9 times and pause. i turn the ignition on but nothing happens please help. Toyota /en/qa/85794/my-evo-one-doesnt-program Sun, 30 Dec 2018 00:58:22 +0000 /en/qa/84834/2006-jeep-grand-cherokee-dtcs-after-remote-start-is-used I purchased a evo all stand alone remote start with the T harness. After installing the unit I tested the remote start and everything seems to work as intended but I noticed that after using the remote start the check engine light on. So I read the codes and cleared them with my snap on solus ultra scanner. I then started the truck with the key to confirm they were cleared and all was good. I tried the remote start and again after it started the truck I have the same 3 DTCs<br /> <br /> U110A Lost communication with steering column module - CAN- C<br /> <br /> U0103 Lost communication with electric gear shift module<br /> <br /> U1411 Implausible fuel volume signal received<br /> <br /> The unit also does not turn on the heat or A/C. Nothing on the dash is on radio, gauges etc. Jeep /en/qa/84834/2006-jeep-grand-cherokee-dtcs-after-remote-start-is-used Sat, 10 Nov 2018 12:18:24 +0000