/en/qa/tag/ultrastart-u1272 Powered by Question2Answer /en/qa/7373/can-you-help-eliminate-confusion-hooking-up-evo-all-to-ultrastart-u1272-pro After looking at the wiring diagram here for a 2009 Kia Sedona and comparing this to the hookup guide available from Fortin website I am confused as to which wires need to be hooked into the car on the Evo-All and which wires need to be hooked directly to the remote start module.<br /> <br /> If I have this correct I THINK the Evo-All should hook to the Can-Bus and Can-Bus2, the ignition, and a Red data wire located near the ignition. Then the data-link wire should hook to the UltraStart module.<br /> <br /> What I cannot figure out is what parts of the system will NOT be activated/controlled by the Evo-All module and will have to be wired from the UltraStart nodule directly. Kia /en/qa/7373/can-you-help-eliminate-confusion-hooking-up-evo-all-to-ultrastart-u1272-pro Thu, 26 Dec 2013 08:54:12 +0000