NIST4 Harness

Question

Is it necessary to cut the 15 pin white connector that contains the red and black wires (power and ground) on the NIST4 harness for the 2016 Infiniti Q50 3.0 as shown on Guide #75841?

 

Guide # 75841

 

Answer 1

yes and connect them to power and gound

Comments

what do you mean cuting the wire from the bcm or which side ?

---

When using the NIST4 harness if it hasnt already been done you must not use the 15 pin connector and manually connect power and ground to the BCM as shown on page 4 of the installation guide: https://fortin.ca/download/75841/EVO-ALL_IG_TSA_BI_NIS4_Q50-6C_2014_PTS_B_75841.pdf

 

 

---

I didn't understand stand you I have used the t-cable so i have connect the power positive and negative to the 15 pin or not ?

---

Yes you must hardwire power and ground as shown in the installation guide on page 4. Do not plug in the white 15 pin connector.

---

So you mean keep the 15 pin plugged in the BCM and connect the positive and negative from some where else right ?

---

No, do not connect the white 15 pin connector from the NIST4. Cut it off and hardwire 12v and ground to the bcm. 

---

Still same problem and for your information its showing on the meter chassis control faut

---

Can we make a vedio call just yo show you wat is happening because since 4 days and am trying

---

There should be no faults, I would go over the connectors and ensure everything is seated properly.

If it still does not remote start please call into our tech line when you have the vehicle and evo on hand.

1-877-336-7797

Mon - Fri

8am 6pm est

Best regards

---

A contacting you from dubai I can't call this number and i have the vehicle with me now