Questions & Answers

2008 Honda Odyssey OEM remote does not work after remote start

0 votes
2008 Honda Odyssey

EVO-ONE SN:002b04712276

Guide #86291

I have installed the unit according to the guide above.  It programs fine and the van will remote start.  After a remote start the OEM remote will no longer function.  I have read in some other posts that this could be caused by incorrect ignition 2 wiring.  Currently I have ignition 2 connected to pin D3 should it be connected to D1?  What does the "Cut" mean in the wiring diagram for those wires?  Same question for the security light connection. Should it be connected to D4 or D6?   We just unlock the driver door with the key and everything else works as it should but it would be cool if the OEM remote worked to unlock the doors.
asked Jan 11 in Honda by chris majewski (190 points)

1 Answer

0 votes
Hello,

You need to physically cut the vehicles ignition 2 wire. The connect one end to D3 and the other end to D1. This interrupt is what will allow the OEM remote to work once remote started.

Best regards
answered Jan 12 by Derek J (395,120 points)
Ok that makes sense.  Basically the same for the security light wire?  I will make those wiring changes and report back.
commented Jan 12 by chris majewski (190 points)
Yes, same would apply for the security light. Let me know how it works out for ya!
commented Jan 12 by Derek J (395,120 points)
Works perfectly now.  I have these on a couple cars but this was my first non-harness install.  Thanks!
commented Jan 13 by chris majewski (190 points)
Awesome glad that got it going!
commented Jan 13 by Derek J (395,120 points)

Related questions

...