2011 Toyota RAV4 Push Start – Remote Start shuts off first time, runs fine second time

Question

Hi everyone,

I installed a remote starter on a 2011 Toyota RAV4 push start using a Compustar 930S with CM900 brain and Fortin EVO-ALL bypass module.

On the first remote start attempt, the vehicle starts normally, then shuts off after about 5–6 seconds. Immediately after shutting down, the system automatically attempts to start the vehicle again without me pressing the remote, and on this second attempt it stays running normally.

Installation and programming were completed as instructed. No fault lights, and the EVO-ALL appears to be learned properly.

Has anyone seen this behavior before on Toyota push-to-start vehicles?

Answer 1

Hello,

Sounds like you need to program tach to your compustar piece.

Also make sure D2 is not on.

Best regards