2024 Hyundai Elantra N Fortin Evo One LTE Flashes red light 4 times after failed remote start.

Question

All wires seems to be correct from the install manual. Can is reading correct. The car will crank when remote started but nothing. I don't see any security lights on the dash when I attempt to remote start. the red light will flash about 4 times on a failed start. from my understanding its possbily not reading the tach? is theres a recommended setting im missing in pro/wizard? theres no decryption required for the Hyundai correct? and i just program the key on "red" press button 6 times press ignition 2x wait for flashing blue and turn ignition off. I have a 6MT I have updated everything to the most recent firmware. i just cannot seem to figure out the last part. I also have the car under Tech Data-Link. do i have to learn the idle of the car at all for it to stay running? my blue light on the evo one lte dosn't light up when holding brake and holding button to learn tach. Any advice would be great! Thank you!

Answer 1

Hello,

Just want to confirm a few things first:

- ready mode works?

- engine turns over but does not actually run?

- yellow loop has not been cut?

 

"theres no decryption required for the Hyundai correct?" - that is right

 

Best regards

Comments

Hello! Just want to confirm a few things first:

- ready mode works? Correct

- engine turns over but does not actually run? Correct

- yellow loop has not been cut? Yellow loop has not been cut.

---

Alrighty thank you for that.

If the vehicle cranks but does not remote start I would start by verifying what side of the cut you have put the lt.blue/black wire on for the ems com interrupt.

If it is on the wrong side, the module will still program however it will do exactly that, crank and no start.

https://cdn02.fortin.ca/download/121431/EVO-ONE_IG_REG_BI_HYU-ELANTRA-N_2021-2024_PTS_A_121431.pdf

Best regards

---

I switched the wires. works fine now. Thank you!

---

Awesome glad that got it going for you!