2016 KIA K7

Question

Hello. I installed Evo-One on 2016 Kia K7 (on liquid gas...with start-stop).. I specified 2017 Kia Optima in the manager. The EMS wire was behind the passenger kick panel in the red connector on the bottom, second from the right. Behind the fuse, the ignition wire (ON) was pink...the ACC wire was white...the starter wire was yellow with a black stripe. The CAN wires were also located behind the fuses in a small connector... yellow and black... blue and orange. Everything worked well, but after opening the door, when I pressed the brake, the car stopped... When I pressed the start-stop button, the radio turned on, and the start-stop button also showed a yellow LED, but the car stopped when I pressed the brake.

I didn't use the ACC-2. It was blue, behind the fuses.    The customer left satisfied, but I'm wondering what else can be added to prevent the car from stalling when the brake is applied?

If you could please send me the serial number of this Evo-One...I usually write down the numbers in a journal and now I forgot to write them down...

Answer 1

Hello,

I'd take a look at the 17-18 cadenza info, cars look similar.

It even specifies the ems com in a red connector in the pass kick like you stated. It requires a key take over control interrupt for take over to work.

https://www.wirecolor.com/en/vehicles/kia_cadenza_-_push-to-start_(2017-2018)/

Best regards.

Comments

Yeah...I didn't remember that. CAN-2 (CAN-B) isn't on that list. I'll try it later to see if the Take-Over cable helps.